Panasonic SA-HT210 Operating Instructions Manual page 4
Av control stereo receiver
Hide thumbs
Also See for SA-HT210:
- Operating instructions manual (49 pages) ,
- Operating instructions manual (48 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
Available languages
Available languages
Before
use
m
Insert the batteries in
the correct polarities
QOO.
it
f=)
ee
n
oe
Ai
c
f
Avoid any obstacles
Transmission
About 7 meters (23 feet) in front
of the signal sensor. (The actual
range will depend on the angle
at which the remote control is
used.)
i
n
| Accessories
MÀ
WD
BN
Eq
dy M T
—
— 4
—
——
o
M9
MÀ
mt
Please check and identify the supplied
accessories.
A | LJ AC power supply cord (SJA 172) sn
1 pc.
E [] AM loop antenna set (RSAD010)
è AM loop GIG as is eae ic
Pup
dan terrd gira iai 1 pc.
$ AM loop antenna holder.
1 pc.
nent
tu 1pc.
L FM indoor antenna (RSAQ0006) ..................
esses 1 pc.
E
C] Batteries: Ua,
2 pcs.
E O Remote control transmitter (EUR644852) .........-------------- 1 pc.
Use numbers indicated in parentheses when asking for replacement
parts.
(Only for U.S.A.)
To order accessories call PASC Accessory Dept. 1-800-332-5368.
E
—
| Concerning the remote control
d
Battery installation
A
e Thoroughly clean the battery compartment before inserting new
batteries.
* Do not mix old and new batteries, or batteries of different types
(carbon and alkaline, etc.).
e |f you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
è Do not use rechargeable type batteries.
* Do not attempt to recharge alkaline or carbon batteries.
e Always remove old, weak or worn-out batteries promptly and
dispose of them properly.
e Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
* |f the leaking electrolyte comes into contact with skin or clothes,
flush with water immediately.
Battery life
Battery life is about one year.
The batteries should be replaced if the system fails to respond to
commands
from the remote control transmitter even when held
close to the remote control signal sensor.
When you need to replace these batteries
Use two R6/LR6, AA, UM-3.
Method for use
E
Be sure the transmission window and the signal sensor are free
from dust. Excessive dust might affect performance.
The operation may not be correct if direct sunlight or another
strong light source strikes the signal sensor of this unit. If there is a
problem, place the unit away from the light source.
Advertisement
Table of Contents
