Table of Contents
Advertisement
AUTO SETUP
VCR Display
Auto Setup
Tuning
: Ch 21
On-Screen Display
Owner ID
PIN number : ****
Name
: **************
House No
: ***********
Postcode
: ***********
You now have the opportunity
to enter your details and
help the police crack crime
see instruction book.
:
select
:
store
ENTER
:
exit
EXIT
On-Screen Display
16
!
Set the
VCR/TV
switch to VCR.
!
Turn on the TV,
!
then press the
VCR-Stand-by/ON
The VCR will now start Auto Setup.
-
While Auto Setup is running the first digit of the VCR display will flash.
After a while it will stop flashing and the RF output channel number will
be displayed.
-
Select an unused channel pre-set on your TV and tune it to the RF
output channel number shown on the VCR display (or until you can
clearly see the Auto Setup screen). Store the new video playback
channel (refer to the instructions for your TV).
-
If you connect your VCR to the TV by a Scart cable, you do not need
to tune the TV as described above simply select appropriate input
mode on TV.
Owner ID
You can complete the Owner ID now or skip this step and do it later.
To do it later, press the
EXIT
!
To set the Owner ID now, press the
four-digit PIN number.
!
Press , to correct the digit.
!
Make sure that you will remember the PIN number (make a note of it).
!
Press the
ENTER
button twice to confirm.
!
Enter the [Name], [House No] and [Postcode] in the same way.
!
Press the ENTER button to confirm each entry.
!
Press the
EXIT
button to leave the Owner ID screen.
!
You will now see the TV picture. Your VCR is now ready to use.
button to switch on the VCR.
button again. Your VCR is now ready to use.
Numeric
buttons or
VCR
TV
to enter a
Advertisement
Chapters
Table of Contents
