Operating instructions Touchtronic G 832 SC To prevent accidents and machine damage, read these instructions before installation or use. M.-Nr. 05 620 641...
Installation Installation and repair work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and could void the warranty. , WARNING - Fire hazard Do not cover or crush the plug of an electric appliance.
Page 5
However, under certain conditions it may be possible for an installation in these applications. Please contact the nearest Miele dealer or the Miele Technical Service Department with specific requirements. Inspect the dishwasher for shipping damage.
Page 6
When discarding an old dishwasher, unplug it from the power outlet, remove the door to the wash cabinet and cut off the power cord.
CONSIGNES DE SÉCURITÉ IMPORTANTES AVERTISSEMENT – Lorsque vous utilisez votre lave-vaisselle, veuillez prendre des précautions essentielles, y compris ce qui suit. Lisez attentivement l’ensemble des consignes avant d’installer ou d’utiliser le lave-vaisselle afin de prévenir les blessures et éviter d’endommager l’appareil. Le fabricant ne peut être tenu responsable des dommages ou blessures causés par une utilisation...
Page 8
Toutefois, son installation est possible dans certaines circonstances. Veuillez communiquer vos exigences particulières au détaillant Miele le plus près de chez vous ou au Service technique. Vérifiez si votre lave-vaisselle n’a pas subi de dommage lors du transport.
Page 9
CONSIGNES DE SÉCURITÉ IMPORTANTES Utilisation N’utilisez le lave-vaisselle que lorsque tous les panneaux sont bien en place. Ne jouez pas avec les commandes. Afin de diminuer le risque de blessures, ne laissez pas les enfants jouer près de l’appareil ni monter dedans ou dessus. Évitez de malmener la porte ou les paniers du lave-vaisselle ou de vous y appuyer ou asseoir.
^ For fastest possible wash times, yet higher energy consumption, connect the dishwasher to a hot water source. ^ Make full use of the baskets without overloading for the most economical washing.
Upper spray arm (not visible) Cutlery tray Upper basket Water feed for middle spray arm Middle spray arm Lower spray arm Guide to the dishwasher Four height adjustable feet Triple Filter System Salt reservoir Detergent dispenser Rinse aid reservoir Data plate...
Program list/indicators Check/Refill indicators Program sequence display "Start/Stop" button Every dishwasher is tested before leaving the factory. Any water remaining in the machine is from these tests and does not indicate that the machine has been used. "Top solo" button...
To open the door ^ Press the release catch inside the door grip. If the door is opened during operation, the dishwasher will stop running. Once the door is closed the program will restart. To close the door ^ Push the baskets in.
Before using for the first time Water softener To achieve good cleaning results, the dishwasher needs soft water. Hard water results in calcium deposits on dishware and in the dishwasher. If your tap water hardness is above 8 gr/gal (values are in US gallons) (140 ppm), the water should be softened.
^ Make sure the dishwasher is turned off. ^ Press and hold the "Start/Stop" button (17) and at the same time turn on the dishwasher with the "On/Off"...
The selected program indicator (14) and the "Rinse" (16) indicator will flash. ^ To store this setting press the "Start/Stop" button (17) twice. ^ Turn the dishwasher off with the "On/Off" button (13). Checking the programmed water hardness ^ Make sure the dishwasher is turned off.
Page 17
Other salts may contain insoluble additives which can impair the water softener. The proper salt can be purchased from your Miele dealer or Miele. Inadvertently filling the salt reservoir with dishwashing detergent will damage the water softener.
"Salt-PC" indicator will light, indicating that it should be refilled with reactivation salt. After the reservoir has been filled, the water softener is automatically reactivated the next time the dishwasher is started. The "Salt" indicator will be lit during this process.
Rinse aid Rinse aid is recommended to prevent spotting on dishes and glassware. Filling the rinse aid reservoir with detergent will damage the reservoir. Only pour rinse aid formulated for residential dishwashers into the reservoir. Adding rinse aid ^ Add rinse aid before the first use and whenever the "Rise aid"...
Before using for the first time Adjusting the dosage The dosage selector is preset to 3. This dispenses approximately 3 ml of rinse aid per program. It can be adjusted from 1 to 6. ^ Use a higher setting if spots appear on dry glassware.
^ Food residue and spilled liquids should be cleaned from the sides of the dishwasher door. These are outside of the wash cabinet and are not cleaned by water from the spray arms.
See the "Program guide". – If crystal or delicate glasses will be washed frequently, connect the dishwasher to cold, rather than hot water. – Clouding or etching may occur on glasses after frequent washing. – When purchasing new dishes, glasses and cutlery, make sure they are dishwasher safe.
Loading the dishwasher Spoon heads should be placed in contact with at least one of the serrated retainers of the cutlery tray to ensure that water runs off freely.
Loading the dishwasher Upper basket Adjusting the upper basket On select models, the upper basket can be raised or lowered to accommodate tall items. ^ Slide out the upper basket. ^ Pull up the levers at the sides of the upper basket and adjust the basket height.
Adjustable cup racks Raise the rack to make room for tall glasses. Lower it to double stack smaller pieces. Loading the dishwasher Coffee bar To allow water to run off the bottom of coffee mugs, place them slanted on top of the coffee bar.
Loading the dishwasher Lower basket For larger and heavier items such as plates, serving platters, sauce pans, bowls. Height limit The guide at the front of the upper basket determines the maximum height for items placed in the lower basket so that the middle spray arm is not blocked.
Additional inserts for the upper and lower baskets may be purchased from your Miele dealer or the Miele. Vase / Bottle holder Upper Basket Glassware Insert Basket accessories To wash milk or baby bottles, attaches to the lower basket. To wash long stemmed glassware,...
The horizontal marks in Compartment II indicate levels of approximately 1 and 2 tablespoons (20, 25 and 30 ml) respectively. ^ With the dishwasher door fully open fill compartment II with 2 tablespoons (30 ml) of powder detergent or one detergent tablet.
Important program steps could be omitted (e.g. reactivating the water softener). Waterproof System All Miele dishwashers are specially designed to shut off the water intake and drain the wash cabinet in the rare event of an internal water valve failure.
At the end of a program The "End" indicator will light when the program has finished. ^ Turn off the dishwasher. ^ Open the dishwasher door slightly to allow the dishes to cool before unloading. It is advisable to turn off the water supply if the dishwasher will not be used for a period of time (e.g.
Program guide Program Pots & Pans For heavily soiled pots and pans with dried on food Main wash temperature 170 °F (75 °C) Run-time 129 min Sani Wash Extended wash time For sanitizing normally soiled dishware with dried on food Main wash temperature 150 °F (65 °C) Run-time 135 min Normal Plus...
Because a smaller load is being washed the amount of detergent recommended can be reduced to 1 tablespoons. ^ Turn the dishwasher on using the "On/Off" button (13). The "Start/Stop" (17) indicator will flash. ^ Select a program using the program selection buttons (19).
The "Extended drying" feature can also be activated to prevent condensation from collecting on the steam deflector. Turning extended drying on/off ^ Make sure the dishwasher is turned off. ^ Press and hold the "Start/Stop" (17) button and at the same time turn the dishwasher on using the "On/Off"...
Close the door firmly. Insert the plug. Reset the circuit breaker Make sure it is a 15 A breaker. Reset the circuit breaker Make sure it is a 15 A breaker. See maintenance instructions. Call the Miele Technical Service Department. Contact a plumber.
– Turn off the dishwasher. A few seconds later: – Turn the dishwasher on. – Select the desired program. – Press the "Start/Stop" button. If the indicators flash again, there is a technical problem. – Call the Miele Technical Service Department.
Interrupt the program and rearrange loose pieces. This has no effect on the dishwasher. If in doubt contact a plumber. Increase the dosage or refill the reservoir, see "Before using for the first time".
Reseat it making sure it screws back on correctly. Raise setting of the water softener , see "Before using for the first time". Reduce the dosage, see "Before using for the first time". There is no remedy. Only wash dishwasher safe glasses.
Use more detergent, see "Adding detergent". Discoloration is permanent. Reseat and screw the cap on firmly. There is no remedy. Only wash dishwasher safe cutlery. Dry the dispenser before adding detergent. Remove the residue. Clean the filter, see the "User Maintenance Instructions".
Miele’s Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home.
Transport To transport the dishwasher, e.g. when moving to a new home, note the following: – Empty the dishwasher. – Secure any loose parts, e.g. hoses, cables, cutlery baskets. – Transport the dishwasher in the upright position. If unavoidable it may be transported on its back.
4 - 6 months or whenever a foreign object is trapped. Cleaning the filter in the wash cabinet ^ Turn off the dishwasher before cleaning. ^ Turn the handle counterclockwise to release the triple filter system. ^ Lift the filter out of the machine.
Page 43
Cleaning and Care ^ Return the filter so it lies flat in the base of the wash cabinet. ^ Lock the filter by turning the handle clockwise. The dishwasher must not be used without the filter locked in place.
Sometimes particles of food get stuck in the spray arm jets. The spray arms should be inspected and cleaned every 4 - 6 months. ^ Turn off the dishwasher before cleaning. Remove the spray arms as follows: ^ Remove the cutlery tray (if present).
The wash cabinet can be cleaned with a dishwasher cleaner such as Dis Cleaner available from your Miele dealer or the Miele Technical Service Department. Cleaning the door and door seal ^ Wipe the door seal with a damp cloth to remove any food particles.
These filters can be purchased from Miele. The plastic valve housing on the intake hose contains electrical components and should not be submerged, or run through water.
Cleaning the drain pump and non-return valve If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. ^ Turn off the dishwasher. ^ Remove the triple filter (see "Cleaning the filter in the wash cabinet").
Page 48
Alterations rights reserved / G 832 Plus 1906 M.-Nr. 05 620 641 / 02 en - US...