1-10. Be careful of children Refers to possibility of injury • There is always the possibility of danger when of a person or damage to doing repairs so make sure that children can’t property. come nearby. Caution Samsung Electronics...
4. Setting Temperature of the Fridge/Freezer SEMI-ELECTRONIC ELECTRONIC ITEM SR-L3928B(A)/L39WEB(A) SR-L3916B(A)/L39NMB(A) SR-L3926B(A)/L39NEB(A) SR-L3616B(A)/L36NMB(A) SR-L3626B(A)/L36NEB(A) Type Type ON( ) OFF( ) ON( ) OFF( ) Warm F-Sensor Normal Cold Type Type OFF( ON( ) OFF( ) Warm F-Sensor Normal Cold Samsung Electronics...
Page 10
Take out food stuffs and pull it out by following Pull it out by following the arrow. the arrow. Take out the water bottle with the bottom latch pressed. • Ice compartment • Freezer compartment • Vegetable/Salad compartment Samsung Electronics...
Power 1 time push 2 time push 3 time push 4 time push 5 time push 6 time push 7 time push 8 time push 9 time push 7 Segment –19˚C –20˚C –21˚C –22˚C –23˚C –24˚C –25˚C –17˚C –18˚C Controlled –19˚C –20˚C –21˚C –22˚C –23˚C –24˚C –25˚C –17˚C –18˚C temperature of freezer Samsung Electronics...
Page 14
So that, cool air will not be supplied to the refrigerator. VAC function does not affect setting up of the temperature of freezer. If you push the button of controlling the temperature of refrigerator while VAC function is working, VAC function will be released automatically. Samsung Electronics...
Page 15
C. HEATER ON/OFF during defrosting The temperature of defrosting HEATER ON General defrosting Forced defrosting Note Same under all defrosting condition below -5 below -5 The temperature of defrosting HEATER OFF 6 hours and Section 19 hours 4 hours Note 50 minutes Samsung Electronics...
OFF temperature, a clause1) will begin to work. If the evaporator temperature at the inititial POWER ON state is above the defrosting OFF temperature, the NOTCH of FRE.TEMP. and REF.TEMP. will be set to be -19 and 4 , and SUPER, ECO and VAC function does not selected. Samsung Electronics...
Page 17
If bad sensor is detected, any button will not be recognized and all electrical load will be set to be OFF and normal control of temperature will be reserved. If bad part is repaired, it will be restored to the original state. Samsung Electronics...
Page 18
TEMP. and FRE. TEMP. button simultaneously for 5 seconds. D. Forced defrosting 1) BEEP SOUND will be generated with a period of 0.1 second ON/1 second OFF if you push REF. TEMP. and FRE. TEMP. button simultaneously for 5 seconds only once during the forced defrosting. Samsung Electronics...
RAM in MICOM when power is impressed or instantaneous electricity failure is occurred. RESET voltage at the impressed moment of power is maintained as state for a few seconds and High under normal working condition. Samsung Electronics...
Page 20
SENSOR and F-rated resistance are connected to the GROUND and DC 5V, respectively. The resistance value which is changed by the temperature is converted to the voltage, and then respective temperature is discriminated by input voltage to A/D PORT of MICOM Samsung Electronics...
Page 21
ON so corresponding electrical load begins to operate. 8-6. Division of BUZZER TRANSISTOR begins to operate by CLOCK which was generated at MICOM and BUZZER sound is generated by impression of 12V to the BUZZER. Samsung Electronics...
Page 22
LED, the CONTROL terminal of MICOM PIN #8-#11 output the output signal which is coincident with GRID signal. Meanwhile by pushing the KEY which is connected by respective GRID, corresponding signal is inputted to MICOM. Samsung Electronics...
Page 23
MICOM PORT generate the same output with GRID wave form only at initial POWER ON. Shift of temperature in freezer compartment(unit : ˚C) Shift of temperature in refrigerator compartment(unit : ˚C) SHIFT SHIFT Default Default -1.0˚C -1.0˚C -2.0˚C -2.0˚C -3.0˚C -3.0˚C +1.0˚C +1.0˚C +2.0˚C +2.0˚C +3.0˚C +3.0˚C +4.0˚C +4.0˚C Samsung Electronics...
Page 25
2. Check out whether POWER S/W on the PANEL PCB is pushed or not. 3. If additional disorder may detected, check out by referencing the note of next page. 9-1. When the POWER does not transmitted Samsung Electronics...
Page 26
9-2. When the disorder has detected by self diagnosis A. When the Disorder of F-ROOM SENSOR has occurred B. When the disorder of F-EVA SENSOR has occurred Samsung Electronics...
Page 27
C. When the disorder of R-ROOM SENSOR has occurred D. When the disorder of DAMPER REED S/W has occurred Samsung Electronics...
Page 28
E. When the disorder of DOOR S/W has occurred Samsung Electronics...
Page 29
If the moisture or vapor penetrates into the junction and corrodes it, the lamp of refrigerator is kept as OFF state and DOOR OPEN warning does not work because the signal does not inputted to the MICOM. A. When Ding-Dong sound is generated continuously. B. When the beeper sound is generated continuously Samsung Electronics...
Page 30
C. When the KEY of PANEL-PCB has not been selected. Samsung Electronics...
1. Remove a screw from the cover and pull down the cover with the back latch pressed. 2. Pull out the lamp. 3. After replacing the lamp, assemble the front latch of cover and then connect the back latch and screw on the cover. Samsung Electronics...
Page 40
3. Pull out the holder of the cooling cycle unit and disconnect wire terminals. 4. Pull forward the insulating material of the cooling cycle unit and remove the wire terminal and insulating material. 5. Remove 2 screws securing refrigerator duct and pull it out by following the arrow. Samsung Electronics...
Page 41
6. Remove 3 screws from the back cover of the cooling cycle unit and remove the latch with (+) driver. Remove 3 screws 7. Remove the latch of the cooling cycle unit cover from the bottom. Assembly of the cooling cycle unit in the freezer Samsung Electronics...
Page 42
11-4. Assembly of mechanic compartment in the refrigerator 1. Remove the screws from the securing cover of the mechanic compartment at the back bottom. 2. Mechanic compartment assembly Samsung Electronics...
Page 43
Make sure the power plug is taken out when replacing the components for the main PCB. 1. Disconnect the power cord. 2. Remove the cover of electrical box with insert driver.( ) 3. Assembly specification of electric box TEST S/W Condenser D/C Trans Samsung Electronics...
Page 44
With the door open, unscrew screws with a screw driver(“+” type). Lever out top table with a screw driver (“ _ ” type). Repair or change electric parts of top table. Attach the top table and click into hook by pressing. Samsung Electronics...