Page 1
Stainless Steel Hot and Ice Cold Water Cooler Model No.: 7LIECH-SSF-WL USERS’ MANUAL SAVE THIS MANUAL FOR FUTURE USE For service, call 1-855-594-4755 or e-mail Whirlpool@electrotemp.com 7LIECH-SSF-WL 5M010993XN01(E+S)
Model # 7LIECH-SSF-WL: Page 2 TABLE OF CONTENTS Safety Precautions-Electrical Requirements ........Safety Precautions ................Product Features ................Key Information for Future Use ............Specifications ..................Parts & Features ................Unpacking and Assembly ..............Installation ..................Operation ................... Cleaning Prior To Initial Use .............
Model # 7LIECH-SSF-WL: Page 3 SAFETY PRECAUTIONS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and your appliance. Always read and follow all safety messages. This is the safety alert symbol.
Model # 7LIECH-SSF-WL: Page 4 PRODUCT FEATURES Congratulations! You have chosen a technology advanced, state-of-the-art water cooler. The refrigeration system on this cooler cools the cold water by internal evaporator of commer- cial design flat forms the ice around it. This feature is called an "Ice Bank". It allows for ice cold water and keeps the water temperature consistently cold, however a Longer time in forming the Ice Bank is required.
Model # 7LIECH-SSF-WL: Page 6 UNPACKING AND ASSEMBLY WARNING Remove the dispenser from packaging: TO OPEN: Tip Over Hazard Do not use water cooler until leveling feet are attached to bottom of water cooler and unit is level. Failure to do so can result in death or serious injury.
Model # 7LIECH-SSF-WL: Page 7 OPERATION IMPORTANT This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void if used with any other liquids such as coffee, tea, juices, beer or wine.
Model # 7LIECH-SSF-WL: Page 8 Dispensing Cold Water Note: After setup, it will take up to 1 hour to get the water to its coldest temperature. During this time, the compressor may run continuously as the refrigeration system builds the Ice Bank as noted in the "Product Features"...
Model # 7LIECH-SSF-WL: Page 9 CLEANING PRIOR TO INITIAL USE To remove any odors or dust that may have accumulated during shipment, you may want to clean the dispenser prior to first use. DO NOT PLUG THE COOLER INTO AN ELECTRICAL POWER OUTLET AT THIS TIME.
Model # 7LIECH-SSF-WL: Page 10 PROPER CARE & DESCALING General Cleaning Perform: As needed Time Required: 5 minutes. Note: Do NOT use abrasive materials or chemical cleaners. They may scratch surfaces and contaminate drinking water. For cleaning hard spots suggest rubbing with toothpaste.
Page 11
Model # 7LIECH-SSF-WL: Page 11 Once unit has completed draining replace drain cap and drain plug. Remove remaining water from cold reservoir by dispensing from both taps into a pitcher. Remove bottle receptacle or collar by turning it counter clockwise and pulling up. Store in a safe place.
Page 12
Model # 7LIECH-SSF-WL: Page 12 Descaling If you use mineral water you will need to descale your hot water tank. When mineral water is used, calcium deposits will block passageways in the hot water tank. This blockage can be observed by the gradual slow down in the flow rate.
Page 13
Model # 7LIECH-SSF-WL: Page 13 3. Place the bucket/bottle into the cooler and close the door. The water will be pumped up into the holding tanks. 4. Plug in the cooler and turn on the hot switch located at the back of the cooler. Do not turn on the cold-water switch.
Model # 7LIECH-SSF-WL: Page 14 TROUBLESHOOTING Minimal or no flow and/or dripping water from water faucets: Make sure that the bottle is not empty. If so, replace per instructions. Ensure that water cooler controls have been fully activated. If you are using mineral or mineralized water, the water cooler hot tank should be descaled every one or two years depending on concentration of minerals.
Model # 7LIECH-SSF-WL: Page 15 LIMITED WARRANTY Electrotemp Technologies Inc., (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.