Advertisement
Quick Links
DESCRIPTION
Fixing frame
INSTALLATION TIPS
When clipsing the front
face, make sure the zone
for the LED is at the bottom.
Do not force when turning
the adjustment screw.
Detection range adjustment
Front face
Use the screwdriver to
remove the front face.
Do not place the sensor
behind metallic plates.
MICROWAVE CONTACTLESS SWITCH
The sensor can be installed
on the surface by using the
accessory XMS-VB.
Do not place the sensor
in the opening range of
the door.
XMS
USER'S GUIDE
Terminal block
Output mode:
Toggle or Pulse
Antenna
LED
after power on
during activation
of output relay
The sensor can be placed
behind tiles, wood, plaster,
plastic and glass.
Avoid moving objects in
front of the sensor
1/4
1/4
Advertisement
Related Manuals for FAAC XMS
Summary of Contents for FAAC XMS
- Page 1 LED is at the bottom. accessory XMS-VB. Do not force when turning Do not place the sensor Do not place the sensor Avoid moving objects in the adjustment screw.
- Page 2 INSTALLATION 70mm 50mm POWER If you do not use the fixation Make a hole as indicated and Connect the wires to the insert the recessed box into the brackets, unscrew them. terminal block. After opening. Pull the wires through Fix the screws of the recessed connection, the LED flashes.
- Page 3 TROUBLESHOOTING SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION Bad or no power supply Check power supply. The door does If LED switches on or flashes, not open even when power connection is OK. moving hand towards the sensor. Detection range is too small. Adjust the detection range.
- Page 4 2004/108/EC. FAAC S.p.A . - Via Calari, 10 40069 Zola Predosa - Italia - tel. +39 051 61724 - fax. +39 051 758518 - www.faacgroup.com Manufactured by: BEA SA - LIEGE Science Park - Allée des Noisetiers 5 - 4031 Angleur - Belgium - T +32 4 3616565 - F +32 4 3612858 - info@bea.be - www.bea.be...