UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
Page 2
By Mike Josiah and the Technical Staff at UniNet The Samsung SCX-6555 is a print/scan/copy/fax engine that runs at 1200 DPI with speeds of up to 55 ppm and has a first page out in less than eight seconds. The monthly duty cycle is 250,000 pages per month. These machines come in multiple configurations with different paper trays, duplexing, 80Gb hard drives, multi-bin mailboxes, and finishers all available.
Page 3
SAMSUNG SCX-6555 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS SUPPLIES REQUIRED 1. 560g new replacement toner for use in the Samsung SCX-6555 2. Replacement chip TOOLS REQUIRED 1. Phillips head screwdriver 2. Small common screwdriver 3. Vacuum approved for toner 1. Remove the two screws located on the waste chamber.
Page 6
SAMSUNG SCX-6555 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 9. Press in on the four tabs on the opposite side of the cartridge. Remove the end cap. 10. Replace the chip on the cartridge. Note that the OEM chip is a contact-type chip that uses a cable and RJ-45 type connector.
Page 7
SAMSUNG SCX-6555 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 11. Snap the connector in place. Make sure the connector 12. Install the end cap so that all four tabs lock it in place. protrudes to the correct distance from the end cap (will be cor- rect when it snaps in place).
Page 8
SAMSUNG SCX-6555 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS CARTRIDGE TROUBLESHOOTING On this type of cartridge, there is really nothing that can go wrong - print wise, but there is one plastic failure point that you need to be aware of. After a few cycles, the plastic clip indicated here can wear down, and not allow the handle to lock in place properly.