Related Manuals for Canon 50/50e
Summary of Contents for Canon 50/50e
- Page 1 EOS 50/50e Elan II/IIe Operator’s Manual prepared by Jim Strutz, updated by Niloy J. Mitra 9th August 2002 http://eosdoc.com/manuals.asp?q=ElanII...
-
Page 2: Table Of Contents
Contents 1 Introduction 2 Camera Top Controls 2.1 Shutter Button ......2.2 Main Dial ....... . 2.3 Command Dial . - Page 3 7 Optional Equipment 7.1 Battery Packs / Grips ......7.2 Remotes ....... . 7.3 Viewfinder Options .
-
Page 4: Introduction
field (DOF) preview. EOS, by the way, stands for Electro Optical System. In writing this instruction manual for the Canon EOS 50/50e and Elan II/IIe, I have assumed that the user has a basic understanding of lens focal length, lens apertures, focusing, shutter speeds, exposure, film type and speeds, as well as SLR cameras and... -
Page 5: Command Dial
Figure 1: Top View 2.3 Command Dial On the top left of the camera you will find the Command Dial. It selects the camera’s exposure modes and other functions. The red L position is Lock, or the camera off position. To turn the dial from the L position, press in the metal tab on the front of the dial. - Page 6 Figure 2: Command Dial ing. The primary advantage of P mode over full auto mode is that in P mode you can use the Main Dial to shift the relative values of the shutter and aperture selection. This is called Program Shift and it provides a way for you to bias the exposure towards faster shutter speeds or smaller apertures while the camera insures accurate exposures.
- Page 7 (smallest number) and the camera will automatically select the fastest shutter speed setting that will still provide the correct exposure. While in Av mode, you can also use the QCD to change/bias the exposure up or down (AEC). This is only the ambient exposure bias and it does not effect the flash exposure.
-
Page 8: Metering Mode
and hold the shutter button until the camera beeps. You’re all done, but you should do this repeatedly in different kinds of lighting. The more you recalibrate, the more accurate ECF will become. There are three different calibration settings that can be used for different people or for when you wear glasses, contacts, etc. -
Page 9: Focus Mode Switch
macro and telephoto use. You can cancel the Self Timer during this 2 or 10 second wait, before the shutter fires by pressing the Self Timer button again. The RC-1 IR remote control is relatively inexpensive and works very well for numerous situations. -
Page 10: Film Advance Switch
If the subject moves the focus follows. Sometimes you want to focus on a particular distance and then recompose with your subject off center. You can do this by selecting a side AF point, or by autofocusing in One Shot mode and holding the shutter button half way down to keep that focus distance selected. -
Page 11: Other Camera Controls & Features
3) Auto DX film speed setting 0 = on, 1 = off 4) Use of * button 0 = AF start with shutter button, exposure lock with "*" button 1 = AF start with "*" button, exposure lock with shutter button 2 = same as 0, plus DOF check with "*"... -
Page 12: Auto Focus Point Selection Button
Figure 4: Back View they only work with the latest Nikon Camera bodies, but the competition on this front is heating up. Also Sigma has some similar HSM lenses that are made in both Canon and Nikon mounts. 3.2 Auto Focus Point Selection Button The other thumb button back here is the AF Point Selection button. -
Page 13: Function Button
the QCD. This simply activates the QCD when in the "1" position. I usually leave it on. Others complain that the dial gets moved accidentally, so they keep it turned off. 3.4 Function Button On the camera back near the left side is the Function button. Repeated presses of the button cycle you through several different options. -
Page 14: Film Rewind Button
selection. The exposure counter in the LCD will now display the remaining exposures to be taken on this frame instead of the usual frame number. If you decide you don’t want to use all the Multiple Exposures you selected, simply press the MF button again and then turn the Main Dial until the numbers remaining disappear. -
Page 15: Lens Release Button
space on the left side and pull the film leader out until it lines up with the orange mark on the right side of the open camera, and close the back. If the camera is not already on, turn it on now, and the film will wind to the first frame. Can’t get much easier with 35mm film. -
Page 16: Remote Release Port
Figure 6: Front View units do not cover the side AF points however, so with those flashes, the camera will use it’s own AF assist light when a side AF point is selected. When using some large diameter lenses the left side AF assist light may be blocked by the lens barrel. The dark red circle that houses the AF assist light, close to the shutter button, also houses the receiver for the optional IR remote control, RC-1. -
Page 17: Lcd And Viewfinder Information
4 LCD and Viewfinder Information 4.1 Liquid Crystal Display The liquid crystal display (LCD) on the top right side of the camera, shows quite a bit of information about what is going on with the camera. At the top left is a numeric display that shows the shutter speed when metering, but is also used to show the film speed, custom function number and eye calibration number. -
Page 18: Viewfinder Display
To the right is the exposure graph. Most of the time the indicator is under the 0 mark, but if you have set Auto Exposure Compensation (AEC) the indicator will move to the - or the + side to show how much compensation you are using. It has a +/- 2 stop range. -
Page 19: Flash
farthest right, bottom indicator is a dot to show that the camera has found something to focus on. 5 Flash 5.1 Built In Flash The Elan II/IIe’s Built In Flash is TTL only. Like all such built in flash units, it is limited by its low power. -
Page 20: E-Ttl Features
E2 has no flash built in, but can be used as the shoe mounted master instead of using another flash for this. The Sigma EF-500 Super is a third party 550EX clone and can also be used as either a slave or a master. -
Page 21: Auto Fill Flash Reduction
highest sync speed (1/125 sec.). Also as light levels increase, to the point of over exposure by the brighter ambient light, the lens aperture will get increasingly smaller. With the camera in Av, Tv and M modes, the camera meter will insist on a full and proper ambient light exposure in addition to your flash exposure. -
Page 22: Lenses
You will also have more things to set on the flash (ISO, aperture, zoom) and on the camera you will have to manually set the lens aperture to what the flash says, and you will have to make sure that your shutter doesn’t exceed 1/125 second. Still, with all that, auto flash is a bargain if power and versatility are the main considerations. -
Page 23: Optional Equipment
designed for cameras like the early Pentax Spotmatics. Some of the lenses were very good and can be found cheap. There are also adapters made to fit older Canon manual focus lenses, but these will either not allow infinity focus or will increase the focal length of your lens with a small teleconverter built in. -
Page 24: Viewfinder Options
full press to fire the shutter. It also has a switch lock to keep the lens open in bulb mode without having to hold the button. 7.3 Viewfinder Options Dioptric Corrective Lenses ED are available to correct vision problems. The Elan II/IIe has 19.5mm of eye relief. -
Page 25: Lens Incompatability
the repair process was a bit tricky. Fortunately this hasn’t proven to be as frequent a problem as many people expected that it would be. 8.2 Lens Incompatability Other than problems with the battery compartment, the most frequently reported trou- ble seems to be an incompatibility with some third party lenses.