Page 1
ORDER NO ECD0602001C2 Vacuum Cleaner MC-E4111-KP47 MC-E4113-KP47 Destination : Europe Model MC-E4111 MC-E4113 Power source 230-240V 230-240V 50Hz 50Hz Input power (IEC) 1500-1600W 1500-1600W Mains lead length 6.7m 6.7m Radius of operation Net weight 6.6kg 6.6kg Dimensions (L×W×H) 330×320×1100 330×320×1100...
MC-E4111-KP47 / MC-E4113-KP47 3.2. BELT (Beater bar belt) 3 REPLACEMENT OF MAIN PARTS 1. Remove the base plate and motor shaft belt as explained previously in paragraph 3.1 Motor shaft belt, point 1-2. IMPORTANT: Before replacing part always 2. Lift the beater bar assembly and remove the belt from the DISCONNECT THE CLEANER FROM THE ELECTRIClTY beater bar pulley and motor pulley.
Page 3
MC-E4111-KP47 / MC-E4113-KP47 3.3. BEATER BAR ASSEMBLY 3.4. MOTOR PULLEY UNlT 1. Remove the base plate as explained previously in 1. Remove the base plate as explained previously in paragraph 3.1 Motor shaft belt, point 1. paragraph 3.1 Motor shaft belt, point 1.
Page 4
MC-E4111-KP47 / MC-E4113-KP47 3.5. MOTOR 5. Remove the motor. Then, remove the two lead wires with a 1. Remove base plate, pedal and motor pulley as explained quick-connect terminal from the carbon brush holder tabs. previously in paragraph 3.4 Motor pulley unit, points 1-4.
MC-E4111-KP47 / MC-E4113-KP47 3.6. CARBON BRUSH 4. Replace the carbon brush holder with new one and insert NOTE: Replace both carbon brushes at the same time. into the motor. (Fig.14) 1. Remove motor case unit and take out the motor as explained previously in paragraph 3.5 Motor, points 1-4.
Page 6
MC-E4111-KP47 / MC-E4113-KP47 3. Remove the lead wire (white) connector from the printed 2. Remove the two screws fixing the printed circuit board circuit board section. (Fig.16) holder to separate the printed circuit board holder A from the printed circuit board holder that covers the printed circuit board.
Page 7
MC-E4111-KP47 / MC-E4113-KP47 3.9. MAIN FUSE 3.10. ON/OFF SWlTCH 1. Remove the three screws fixing the front body to remove it. 1. Remove hose end and front body as explained previously in (Fig. 19) paragraph 3.8 MAIN FUSE. * Point: Lift the front body from below the main unit.
MC-E4111-KP47 / MC-E4113-KP47 8 TROUBLE SHOOTING GUIDE CONDITlON CHECK POINT METHOD OF INSPECTlON CAUSE/REMEDY Motor fails to rotate. Plug (fuse-1ink) Check fuse continuity. lf there is no continuity, replace it. (no noise is heard at all). (UK, lRLonly) Main fuse Check main fuse continuity.