Advertisement
Quick Links
Z Stand
200 and 500 Series Z Master
Model No. 105-1622
This product contains a chemical or chemicals known to the State of California to
Safety
Safety and Instructional
Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Hub
Bracket latch
Bolt (3/8 x 1-1/2 inches)
Lock nut (3/8 inch)
Bolt (3/8 x 3-1/2 inches)
Lock nut (3/8 inch)
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Kit
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
104–7759
Register at www.Toro.com.
®
WARNING
CALIFORNIA
Qty.
1
1
Assemble the Z Stand hub.
1
1
2
Install the Z Stand hub.
2
Form No. 3386-652 Rev A
Installation Instructions
Use
Original Instructions (EN)
All Rights Reserved *3386-652* A
Printed in the USA.
Advertisement
Related Manuals for Toro Z Master 200 Series
Summary of Contents for Toro Z Master 200 Series
- Page 1 Bolt (3/8 x 1-1/2 inches) Lock nut (3/8 inch) Bolt (3/8 x 3-1/2 inches) Install the Z Stand hub. Lock nut (3/8 inch) © 2014—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3386-652* A 8111 Lyndale Avenue South Printed in the USA.
- Page 2 Description Qty. Z Stand Washers Lynch pin Install the Z Stand. Hair pin cotter pin Clevis pin Bracket Bolt (5/16 x 3-1/4 inches) Lock nut (5/16 inch) Install the Z Stand bracket. Bolt (1/4 x 3/4 inches) Lock nut (1/4 inch) Lanyard Note: The following instructions are for installing the Z Stand...
- Page 3 Installing the Z Stand 1. Place only 1 thrust washer onto the pivot pin (Figure 4). Note: Do not use more that 1 thrust washer next to the Z Stand tube. 2. Insert the pivot pin into the hub as shown in Figure 4. Note: When inserting the pivot pin, make sure the position of the slot in the Z Stand tube is as shown in Figure 4.
- Page 4 Operation 3. Raise the latch. Swing the stand foot out to the front and slide the stand toward the machine, into the bottom of slot (Figure 7 and Figure 8). Using the Z Stand 4. Set the foot of the stand on the ground and rest the latch on pivot tab (Figure 8).