Instruction Please prepare below tools before installation: Power drill with drilling bit Tape measure Screwdriver Wrench of Ø12mm Installation procedure 1 、 Pic A Pic B 2 、...
Page 5
3 、 4 、 5 、 580mm 580mm 6 、 10 11 11 10 7 、 through from Through the fabric into roller and front bar...
Page 8
15 、 tight Open tight LOCKING NUTS Check if the awning is level with the use of the spring level (28) on the front bar. Adjust the angle adjuster at either end by loosening the locking nuts of the angle adjuster ,turn the jack bolt to adjust the pitch.Adjust the arm until the front profile is level.Tighten the locking nuts again to fix the level of awning.