Advertisement
Quick Links
Wired Controller Kit
Pro Force
Model No. 119-1100
This product contains a chemical or chemicals known to the State of California to
Note: Determine the left and right sides of the machine from the normal operating position.
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
1. Rotate nozzle left
2. Rotate nozzle right
3. Slow
Loose Parts
Use the chart below to verify that all parts have been shipped.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Debris Blower
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
119-1775
4. Continuous-variable
setting
5. Fast
Register at www.Toro.com.
WARNING
CALIFORNIA
1. Engine—Stop
2. Engine—Run
Form No. 3397-489 Rev A
Installation Instructions
119-1776
3. Engine—Start
Original Instructions (EN)
All Rights Reserved *3397-489* A
Printed in the USA
Advertisement
Related Manuals for Toro 119-1100
Summary of Contents for Toro 119-1100
- Page 1 Form No. 3397-489 Rev A Wired Controller Kit Pro Force ® Debris Blower Model No. 119-1100 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Description Qty. Install the wired controller—for Debris Blowers with serial Wired controller numbers 290999999 and earlier. Wired controller Install the wired controller—for Debris Blowers with serial Wire-harness adapter (used on Debris numbers 310000001 to 311000001. Blowers with serial numbers 310000001 to 311000001) Wired controller Install the wired controller—for Debris Blowers with serial...
- Page 3 Installing the Wired Controller For Debris Blowers with Serial Numbers 310000001 to 311000001 1. Disconnect the battery cables from the battery. Note: Disconnect the negative-battery cable first, and then disconnect the positive-battery cable. 2. Disconnect the wire-harness leads from the wireless-control base (Figure 3.
- Page 4 Installing the Wired Controller For Debris Blowers with Serial Numbers 31200000 to 315099999 (Model No. 44538, 44539, or 44542) 1. Disconnect the battery cables from the battery. Note: Disconnect the negative-battery cable first, and then disconnect the positive-battery cable. g018908 Figure 6 2.
- Page 5 Installing the Wired Controller 4. Disconnect the wire harness from the key switch. 5. Remove the key switch (Figure 10). For Debris Blowers with Serial Numbers 315099999 and later (Model No. 44552, 44553, or 44554) 1. Disconnect the battery cables from the battery and remove the battery.
- Page 6 Figure 12 1. Route the wire harness here. Figure 14 8. Plug the wireless-control-base lead into the harness 1. Wire-harness adapter 5. Yellow wire located by the adapter that was previously disconnected from the hour meter wireless-control base (Figure 13 Figure 14).
-
Page 7: Operation
Operation Controls Using the Nozzle-Direction Button Press the button to rotate the nozzle to the desired direction (Figure 15). g018877 Figure 15 1. Nozzle-direction button 3. Key switch 2. Throttle/engine-speed knob Using the Throttle/Engine-Speed Knob Rotate the knob to F to increase the engine speed, or to to decrease the engine speed (Figure...