Table of Contents
Advertisement
Quick Links
PRODUCTS SELECTION
TABLE OF CONTENTS
Limitation of liability
Product limited warranty
LIMITATIONS OF LIABILITY
This manual is subject to change without notice.
Pach and Company is not liable for any errors that might occur from use of this document, nor is any commitment to
update the information herein implied.
Pach and Company does not assume any liability for any damages, which may arise in installation or use of the Quantum
QWCM. Pach and Company does not assume liability for any incompatibility between the Quantum QWCM and users
devices.
Pach & Company reserves the right to make changes without prior notice to any products in order to improve reliability,
function or design.
PRODUCTS LIMITED WARRANTY
If your product does not work properly because of a defect in materials or workmanship, Pach and Company (referred to
as the warrantor ) will, for the length of the period indicated on the chart below, which starts with the date of original
purchase ( Limited Warranty Period ), at its option either (a) repair your product with new or refurbished parts or (b)
advance replacement with new or refurbished product. The decision to repair or advance replacement will be made by the
warrantor. Advance replacement will be ship UPS ground under the warranty period with no charge.
must be return to Pach and Company within 15 days after receiving the advanced replacement otherwise you will be
billed the full amount.
Parts: Two (2) year, does not cover parts needed to re-install the product by the installer
file:///C|/PACH-CO.COM-2020B/online_manual/qwcm_manual_3.htm[9/14/2020 8:05:57 AM]
The defective product
Advertisement
Table of Contents
Related Manuals for Quantum QWCM
Summary of Contents for Quantum QWCM
-
Page 1: Table Of Contents
Pach and Company does not assume any liability for any damages, which may arise in installation or use of the Quantum QWCM. Pach and Company does not assume liability for any incompatibility between the Quantum QWCM and users devices. -
Page 2: Limited Warranty Limits And Exclusions
The QWCM comes with two year Limited warranty, see above for more detail 1.1 Hardware Specifications Power Input: 12 Vdc (use Quantum Series on board 12 Vdc power supply, using different 12 Vdc power source is not recommended) Current Consumption: 300 mA Dimension including the heat sink: 5-3/4"... -
Page 3: Software Specifications
1.2 Software Specifications Built-in software browser 1.3 Mounting The QMCM must be mounted inside the Quantum Series cabinet. The QWCM is mounted using a sticky on magnet on the right side opening of the Quantum QR5 and QC1. CHAPTER 2 Wiring Diagram and Network Setting A basic knowledge of networking is required to install the QWCM. -
Page 4: Qwcm Direct Connection
2.1 2.3 QWCM Local Area Network (LAN) You must have a local area network with one available Ethernet port for each of the QWCM. Contact your IT department for the router configuration set-up. See diagram below for typical LAN connection. -
Page 5: Internet
PRODUCTS SELECTION 2.4 Internet The QWCM can be accessed via Internet. Consult your IT department to configure the router to accept port forwarding. file:///C|/PACH-CO.COM-2020B/online_manual/qwcm_manual_3.htm[9/14/2020 8:05:57 AM]... -
Page 6: Chapter 3 Resetting The Qwcm
PRODUCTS SELECTION CHAPTER 3 Resetting the QWCM In case the password and network setting have been forgotten, you can reset the password and the network setting to factory default. Follow the steps below 1. Press and hold the reset black button for 10 seconds... - Page 7 3. The network setting will return to IP ADDRESS: 192.168.1.230 SUBNET MASK: 255.255.255.0 DEFAULT GATEWAY: 192.168.1.1 DNS ADDRESS: 192.168.1.1 User Name: Administrator Password: 8888 pach THE QWCM ONLY WORKS WITH QR5 OR QC1 FIRMWARE DATED 12-12-2011 OR LATER file:///C|/PACH-CO.COM-2020B/online_manual/qwcm_manual_3.htm[9/14/2020 8:05:57 AM]...