Related Manuals for Toro 04479
Summary of Contents for Toro 04479
- Page 1 Form No. 3445-360 Rev A Dethatching Unit Greensmaster ® 3000 Series Traction Unit Model No. 04479—Serial No. 408000000 and Up *3445-360* Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Contents Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Safety ............... 3 Dealer or Toro Customer Service and have the model General Safety ........... 3 and serial numbers of your product ready. Figure 1 Cutting Unit Safety.......... -
Page 3: Safety
• Use your full attention while operating the • Use only accessories, attachments, and machine. Do not engage in any activity that replacement parts approved by Toro. causes distractions; otherwise, injury or property damage may occur. Blade Safety • Do not put your hands or feet near moving components of the machine. -
Page 4: Setup
Setup Installing the Front Roller No Parts Required Procedure The dethatching unit is shipped without a front roller. Install the roller using the loose parts supplied with the dethatching unit and Installation Instructions included with the roller. g016405 Figure 3 1. -
Page 5: Installing The Hoop Link, Offset Link, Or Chain Link
• On the left end of the dethatching unit, apply An offset link (Part No. 110-2397) is required a light coating of oil to the O-ring and install for the Greensmaster 3250-D traction units (it is the counterweight with the screws previously supplied with the Greensmaster 3250-D traction removed. -
Page 6: Adjusting The Reel Blades For Positive Setting (Above Ground)
Rotate the height-of-cut until both ends of the front roller contact the level surface. Verify contact by using a piece of paper to check each roller end. Tighten both height-of-cut knob locknuts. g011932 Figure 7 Adjusting the Reel Blades 1. Chain link 2. -
Page 7: Installing The Dethatching Unit
Tighten both height-of-cut knob locknuts. Installing the Dethatching Unit No Parts Required Important: If you set the dethatching reel at a negative setting, take care to prevent damaging the reel blades, due to contact with concrete floors or paved surfaces. Note: The dethatching unit comes configured for left-hand drive from the factory. -
Page 8: Product Overview
To ensure optimum performance and continued safety Adjust the dethatching unit when changing settings certification of the machine, use only genuine Toro as desired. replacement parts and accessories. Replacement Note:... -
Page 9: Maintenance
(Part Number 121-6675), replace the end hex spacer (Part Number 120-3232—shown in Figure with a main spacer (Part Number 120-3167). Contact your authorized Toro distributor for parts information. Note: The end hex spacer is located between a pair of hex spacers and a hex nut as shown in... -
Page 10: Servicing The Roller
The Roller Rebuild Tool Kit includes all the tools and the installation instructions required to rebuild a roller with the roller rebuild kit. Refer to your parts catalog or contact your authorized Toro distributor for assistance. g346125 Figure 12 5. - Page 11 Notes:...
- Page 12 Notes:...
- Page 13 Notes:...
- Page 14 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
- Page 15 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact your Authorized Toro Service Center.