Table of Contents
Advertisement
REPLACE THE LITHUM BATTERY" section.
[STEP 4. RESET THE IC6001 AT ONCE]
1. Connect the AC plug.
2. Connect a jumper wire between TL7510 and TW6090 (GND) for a
second to reset the Microprocessor IC6001.
Note:
Since the resistance at pin 1 as well as pin 2 of IC6001 decides the
model distinction data, no need to set up the Model code, which is
necessary in previous model.
[STEP 5. LINE INPUT SETTING]
1. Connect the 1.5 V battery to TL6010 or Pin 6 of IC6001 until the
FIP displays unreadable irregular characters.
2. Disconnect the AC plug for few seconds and connect it again.
3. Confirm that "A1" and "A2" can be displayed on the FIP by
pressing the CH UP and CH DOWN buttons.
Note:
1. To set-up the "Plug in Auto Tuner Preset", press the Channel up
and down keys simultaneously for 3 seconds.
2. Change the OSD setting to the Factory shipping condition if
necessary, by referring following charts.
[STEP 6. NAVI. DATA WRITING/SAVING]
1. Connect the Prog. Navi. Data Back-up Tool (VFK1493P)
5
Advertisement
Table of Contents
