Page 1
— USER MANUAL HVC 100C / HVC 150C with Depot Charge box User and Operation Manual...
Page 2
In no event shall ABB be liable for direct, indirect, special, incidental or consequential damages of any nature or kind arising from the use of this document, nor shall ABB be liable for incidental or consequential damages arising from use of any software or hardware described in this document.
All rights reserved. Contents Glossary ................................4 1 Introduction ..............................5 Preface ................................5 Intended use of this document........................5 Intended use of the charger .......................... 5 Owner responsibilities ............................ 6 Signs..................................7 Safety regulations ............................8 2 Description of the product ...........................9 Overview of the system ..........................
Glossary Combined Charging System. A universal AC and DC charging system, also referred to as ‘Combo’. Direct Current. Electric Vehicle. Owner The legal owner of the charger. OCPP Open Charge Point Protocol. Open standard for communication with charge stations. Protective Earth. RCBO Residual-current Circuit Breaker with Overload protection.
Introduction Preface The HVC-R product line is the new ABB solution for Overnight Charging of Heavy Vehicles. The product line allows 100kW and 150kW charging with a Dual Depot Charge Box equipped with two charge outlets. The charging of the vehicles is done sequentially following the first come, first serve principle.
ABB’s warranty. Neither ABB nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs or expenses incurred by purchaser or third parties as a result...
DUA L D E P OT C HA RGE B OX Signs The following signs are placed on the equipment and utilized in this manual: DANGER Hazardous voltage Identifies a hazard that could result in severe injury or death by electrocution. WARNING Various Identifies a hazard that could result in severe injury or death.
DUA L D E P OT C HA RGE B OX Safety regulations WARNING If a charge outlet is damaged, take the following steps: Do not use the damaged charge outlet. 2. Contact the Owner / Site Operator. WARNING If there is an emergency Push the emergency stop.
DU A L D E P OT CH A RGE BOX Description of the product Overview of the system A. Power Cabinet 100-150kW B. Depot Charge Boxes Power Cabinet Door Door handle / lock 3G Antenna Air inlets (also on the left and back side) Air outlet CAUTION The Power Cabinet has air inlets (D) and an air outlet (E) to control...
DU A L D E P OT CH A RGE BOX Dual Depot Charge Box The user-operated components are indicated below: A. LED beacon 1 B. Emergency stop button C. Stop button 1 D. CCS connector 1 E. Connector holder 1 F.
DUA L D E P OT C HA RGE B OX Charger configurations The charger is built up with a modular architecture. Supported charging standards in a charger configuration are described below: Product Description HVC-100R CE 100kW Power Cabinet configuration with 1 Dual Depot Charge Box, supporting CCS-2 with CE certification HVC-150R CE 150kW Power Cabinet configuration with 1 Dual Depot Charge Box,...
DUA L D E P OT C HA RGE B OX Charging instruction Charging with one Dual Depot Charge Box Start charging: Park the electric vehicle so that the charge inlet is located within reach of the connector. 2. Turn off the electric vehicle. 3.
DUA L D E P OT C HA RGE B OX Emergency stop In case of an emergency: Push the emergency stop button (B in figure 2). The Charger stops the operation and the LED beacon of the Depot Charge Box will be red.
The following points must be checked regularly: Correct functioning of the internal RCDs and RCBOs needs to be tested on a regular basis. During the advised yearly maintenance round executed by a certified ABB technician, this will be checked. 2 0 21- 0 6- 17...
2. Reset the emergency button by turning the knob clockwise. After a few moments, the charger returns to its idle state. 4.2.3 Special inspections In the following cases the charger must be checked by ABB service personnel before further use: If it was struck by lightning.
DU A L D E P OT CH A RGE BOX Do not open the Power Cabinet door if you are not familiar with working with high voltage and high current. 4.3.2 Overview of the Dual Depot Charge Box Front door of the Dual Depot Charge Box Door handle / lock (unique key for each of the Boxes) WARNING Do not open the Dual Depot Charge Box’s door if you are not qualified for working...
DUA L D E P OT C HA RGE B OX 4.3.3 Component overview of the Power Cabinet The main components can be seen when the front door is open: Main switch MCB (Q17) AC power supply for ACM RCD (Q13) control RCD (Q12) redundant control Display 4.3.4 Component overview of the Dual Depot Charge Box...
DU A L D E P OT CH A RGE BOX Technical functioning 4.4.1 Normal operation Normal positions of the switches and breakers when the charger is in operation (idle; not charging): Power Cabinet Main switch (A): Vertical (“1”) ...
DU A L D E P OT CH A RGE BOX 4.4.3 Switching the Depot Box off In case it is necessary to switch off the Depot Box, it can be done by turning off the main switch: Open the front door. 2.
DU A L D E P OT CH A RGE BOX Contact information NOTICE In case of any problems Contact the Site Operator. ABB Service department - PLEASE INSERT YOU CONTACT DETAILS- 2 0 21- 0 6- 17 2 0/2 2...
Page 21
DUA L D E P OT C HA RGE B OX Appendix: A. WEEE disposal – 2012-19/EU 2 02 1- 0 6- 17 2 1/ 2 2...
Page 22
DU A L D E P OT CH A RGE BOX NOTES 2 0 21- 0 6- 17 22 /2 2...