Advertisement
Quick Links
Blower and Drive Kit
For 52in E-Z Vac® Bagger for Z400 and Z500 Series Z
Master® Mowers
Model No. 78537—Serial No. 260000001 and Up
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
No parts required
2
No parts required
3
No parts required
4
Pulley assembly
Pivot bracket
Metal template
5
Bolt (3/8 x 1 inch)
Locknut (3/8 inch)
Blower assembly
6
Bagger belt
Blower belt cover
Step
1
Verifying an Existing Pivot
Tube
No Parts Required
Procedure
If your mower has a pivot tube as shown in Figure
1, then proceed to Step 6 and the Operator's
Manual to install the blower assembly.
Note: Do not remove the existing pivot tube.
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
1. Z400 mower deck
2. Pivot tube
Register at www.Toro.com.
Form No. 3355-379 Rev B
Installation Instructions
Qty.
–
Verify an existing pivot tube.
Prepare the mower and remove the
–
belt cover.
Remove the existing anti-scalp
–
roller and bracket.
1
Install the pulley assembly.
1
1
Install the pivot bracket.
3
3
1
Install the blower, bagger belt,
1
spring, and belt cover.
1
Figure 1
3. Z500 mower deck
4. Pivot tube
Original Instructions (EN)
Use
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 78537
Summary of Contents for Toro 78537
- Page 1 Blower and Drive Kit For 52in E-Z Vac® Bagger for Z400 and Z500 Series Z Master® Mowers Model No. 78537—Serial No. 260000001 and Up Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position.
- Page 2 Step 1. Remove the anti-scalp roller from the bracket by loosening and removing the flange nut (3/8 inch) and axle bolt (3/8 x 4-1/2 inch) as shown in Figure 2. 2. Remove the three carriage bolts (3/8 x 3/4 inch) and flange nuts (3/8 inch) securing the Preparing the Mower and bracket to the mower (Figure 2).
- Page 3 2. Loosen, but do not remove, the tapping bolts on the existing mower deck pulley (Figure 3). There should be a 3/16 inch (5 mm) clearance between the bolt head and pulley. 3. Align the new pulley assembly so that the openings fit over the pulley bolt heads (Figure 4.
- Page 4 4. Drill three, 13/32 inch diameter, holes into the pilot holes with a sharp drill bit (Figure 5). 5. Remove part of the metal belt cover support on top of the mower. Refer to Figure 5 for the correct size and location to remove. Figure 6 1.