Page 2
License Agreement. 1. License Grant - If you are a party to an applicable written agreement with Honeywell relating to the repair or maintenance of the subject Honeywell Product, subject to your compliance with the terms and conditions of this License Agreement, Honeywell hereby grants you, and you accept, a limited, personal, non-transferable, non-exclusive license to use these Materials only in accordance with that agreement.
Page 3
JetWave™ MCS-8562 Terminal to a Honeywell part, compare a Honeywell part or design of a Honeywell part to another part design, or apply for FAA PMA or other domestic or foreign governmental approval to manufacture or repair a Honeywell part.
Page 7
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL JetWave™ MCS-8562 Terminal TRANSMITTAL INFORMATION THIS IS AN INITIAL RELEASE OF JETWAVE MCS-8562 TERMINAL SDIM ATA NO. 23-15-84 AND IS ISSUED FOR USE IN SUPPORT OF THE FOLLOWING: Table TI-1 shows the applicable components.
JetWave™ MCS-8562 Terminal. The radome selected must be approved by Honeywell in order to meet the performance standards. The radome installation will depend on the radome selected by the installer for each aircraft type. The installer is responsible for the approval and certification of system components on the aircraft, and for the installation of wiring in the aircraft.
To tell Honeywell of a possible data error in a publication. Honeywell Aerospace Contact Team If you do not have access to the Honeywell Technical Publications Website, or if you need to speak to personnel about non-Technical Publication matters, the Honeywell Aerospace Contact Team gives 24/7 customer service to Air Transport &...
Honeywell JetWave MCS-8562 Terminal Architecture This section describes the AES system that Honeywell has implemented for the following classes of terminal: Class A aftermarket satellite terminal: For use on CAT types of aircraft. This uses a FMA assembly. The terminal can also be used in the large aircraft segment of the BRS.
AES Configuration Data NOTE: Any tools for preparing the config files for the terminal must be licensed from Honeywell. The AES configuration data is a set of configuration files, stored on the APM. Each configuration file contains a set of airplane-unique parameters. The parameters define the configuration of the AES necessary for the initialization and operation of the Honeywell JetWave™...
APM configuration files can be requested from the online form on the ASDS portion of the Honeywell portal. Note that the typical lead time between APM file request and APM file is 20 business days, so installers should work this issue early in the installation process.
IF Switch The JetWave™ MCS-8562 Terminal system is capable of supporting an external modem. To install the external modem, the IF coaxial cable path requires an IF switch. Honeywell's recommended configuration uses military specification P/N M3928/10-05 for the IF Switches, along with a control relay (P/N LM-1210-E-MADJV from Applied Avionics, Inc.) capable...
The exact install location of the ARINC 791 based AIM or LAIM and BUC-HPA is airframe specific. The BUC-HPA can be installed on the inside or outside the fuselage of the aircraft. Honeywell recommends to install the BUC-HPA on the ARINC 791 based AIM or LAIM outside the fuselage of the aircraft.
Page 70
The FMA may be installed anywhere on the top of the aircraft, Honeywell recommends not installing the FMA at the mid fuselage station near the wing or slightly aft of the wing due to higher aero loads.