Toro Reelmaster 5010-H Series Installation Instructions
End-weight kit for 8-blade or 11-blade dpa cutting unit with 5in or 7in reel
Hide thumbs
Also See for Reelmaster 5010-H Series:
- Diagnostic manual (476 pages) ,
- Service manual (335 pages) ,
- Operator's manual (128 pages)
Advertisement
Quick Links
End-Weight Kit for 8-Blade or 11-Blade
DPA Cutting Unit with 5in or 7in Reel
Reelmaster
Model No. 03405
Model No. 03411
Model No. 03412
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Weight
O-ring
Bolt
Special shoulder bolt (For 03405 and 03411
models only)
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Determining the End-Weight
Orientation
Refer to
Figure 1
to determine the position of the end weight
and reel motors.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
5010-H Series Traction Unit
Qty.
–
Determine the position of the end-weight and reel motors.
5
5
Install the weight onto the cutting units.
10
5
Register at www.Toro.com.
6
7
7
4
7
6
2
Figure 1
1. #1 cutting unit
2. #2 cutting unit
3. #3 cutting unit
4. #4 cutting unit
Original Instructions (EN)
All Rights Reserved *3388-955* A
Printed in the USA.
Form No. 3388-955 Rev A
Installation Instructions
Use
6
7
1
5
7
6
3
5. #5 cutting unit
6. Reel motor
7. End-weight
6
g027620
Advertisement
Related Manuals for Toro Reelmaster 5010-H Series
Summary of Contents for Toro Reelmaster 5010-H Series
- Page 1 4. #4 cutting unit Refer to Figure 1 to determine the position of the end weight and reel motors. © 2014—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3388-955* A 8111 Lyndale Avenue South Printed in the USA.
- Page 2 Installing the End-Weight Install the end-weight onto the cutting unit (Figure Note: Use Figure 1 to determine where to properly place end-weight. g02751 1 Figure 3 1. Special shoulder bolt g027510 Figure 2 1. Bolt 3. O-ring 2. Counterweight Note: Torque the bolts to 36.6-44.7 N-m (27–33 ft-lbs). For hybrid machines with model numbers 03405 and 03411 only: Before installing the reelmotor, replace the shoulder bolt with a special shoulder bolt as shown in...