Page 1
HP f1703 Service Manual SERVICE MANUAL 17” LCD Monitor f1703 THESE DOCUMENTS ARE FOR REPAIR SERVICE INFORMATION ONLY. EVERY REASONABLE EFFORT HAS BEEN MADE TO ENSURE THE ACCURACY OF THIS MANUAL; WE CANNOT GUARANTEE THE ACCURACY OF THIS INFORMATION AFTER THE DATE OF PUBLICATION AND...
HP f1703 Service Manual 1. MONITOR SPECIFICATIONS Driving system TFT Color LCD LCD Panel Size 43.2cm(17.0") Pixel pitch 0.264mm( H )x 0.264mm( V ) Viewable angle 120˚ (H) 90˚ (V) Response time (typ.) 25 ms Video Analog Input Sync. Type...
HP f1703 Service Manual 2. LCD MONITOR DESCRIPTION The LCD MONITOR will contain an main board, an inverter/power board, keypad board and external adapter which house the flat panel control logic, brightness control logic and DDC. The Inverter board will drive the backlight of panel and the DC-DC conversion.
HP f1703 Service Manual 3. OPERATING INSTRUCTIONS 3.1 GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located at front panel of the monitor. By changing these settings, the picture can be adjusted to your personal preferences.
HP f1703 Service Manual 3.3 ADJUSTING THE PICTURE Brightness/ Adjust the brightness or the difference between the light and Contrast dark area. Adjust the: horizontal position of the screen image. Image Control vertical position of the screen image. frequency of the pixel clock to minimize vertical bar.
HP f1703 Service Manual 4. Input/Outpt Specification 4.1 Input Signal Connector 4.1.1 Analog D-SUB Connector MNEMONIC SIGNAL Red Video Green Video Blue Video None (available for mfg use if required) Ground (DDC Return) Red GND Green GND Blue GND +5 V...
HP f1703 Service Manual 4.2 Factory Preset Display Modes Horz Horz Vert Vert Prese Pixel Freq Polarit Freq Polarit Pixel Clk Format (KHz) (Hz) (MHz) Source 640 x 350 31.469 70.086 25.175 640 x 480 31.469 59.940 25.175 640 x 480 37.500...
HP f1703 Service Manual 4.3 Power Supply Requirements 4.3.1 Input Requirements PARAMETER RANGE CONDITION Input Voltage 90 to 264 VAC RMS Universal input full range Input Frequency 60Hz @ 90VAC to 50Hz @ 264VAC Input Current Less than 2.0 Amps RMS Input voltage 100 VAC RMS ;...
HP f1703 Service Manual 4.4.4 Parameter guide line for CCFL Inverter INVERTER MAX BRINGTHNESS (Vadj:4.0v), LOAD=120KΩX4(ROOM TEMPERATURE 25℃ ±4℃) ITEM SYMBOL MIN. TYP. MAX. UNIT REMARK Input voltage 10.8 13.2 Input current 2300 2550 FOR 4 LOAD Output Current Iout...
HP f1703 Service Manual 5.2 Software Flow Chart...
Page 17
HP f1703 Service Manual 1) MCU initialize. 2) Is the eeprom blank ? 3) Program the eeprom by default values. 4) Get the PWM value of brightness from eeprom. 5) Is the power key pressed ? 6) Clear all global flags.
HP f1703 Service Manual 6. Schematic 6.1 Main Board 715L-1006-1 ADE3000SX 17" LCD Control Board Rev.G Mannequin 17" CONTENTS SCHEMATIC SHEET Title Page ADE3200 Input Interface Damping Resister Output Interface 8051 Microcontroller Title ADE3000 LCD Control Board Board Power Supply...
Page 22
HP f1703 Service Manual INPUT INTERFACE VGA_5V BAT54C AVDD_3.3 BAT54CFILM Highest Priority to input RED, GREEN, BLUE and A_HSYNC (from CON3 to U1). The route width of RED, GREEN, BLUE and A_HSYNC BAV99 BAV99 BAV99 should be larger than 16 mils. The signals should be on the top layer...
HP f1703 Service Manual 6.3 KeyPad Board CN103 B-LED1 O-LED1 ON/OFF RIGHT LEFT MENU LED101 SW105 MHB10-1411QBQYC POWER CN102 RIGHT LEFT MENU CONN Title ADE3300 LCD Control Board Size Document Number Power Key,LED board Date: Thursday, November 14, 2002 Sheet...
HP f1703 Service Manual 8. Maintainability 8.1 Equirements and Tools Requirement 1.) Voltmeter. 2.) Oscilloscope. 1.) Pattern Generator. 2.) DDC Tool with a IBM Compatible Computer. 3.) Alignment Tool. 4.) LCD Color Analyzer. 5.) Service Manual. 6.) User Manual.
HP f1703 Service Manual 8.2 Trouble Shooting 8.2.1 Main Board 1.NO SCREEN APPEAR Measured CN6,pin3/4 ->5 V Check inverter/DC-DC power board ,pin6/7 ->3.3 V ,pin9 ->1.8 V Yes, all DC level exist Power key on/off monitor,LED function ok? Connected the Signal cable again, Led no function (Blue <->...
HP f1703 Service Manual 2.PANEL-POWER CIRCUIT Check the panel power relative circuit, R50,R56, U7,Q3,R132 check U7,pin2,4 ->0V When power switch on In normal operation, when LED =BLUE, R50 should =0 v, NG, no Voltage Measured the U7 pin 5-8= 5 V? Check Q3 pin B= 0.8V...
HP f1703 Service Manual 8.2.2 Power/Inverter Board 1.) No power CHECKED ON FUSE TO CHANGED FAIL PASS F101 Vin=12 F101=6.5A/63V TO CHECKED 5V TO CHANGED PASS FAIL PASS BAT9741 PIN10 F102 OUTPUT 5V TO CHECKED 3.3V TO CHANGED PASS FAIL...
Page 34
HP f1703 Service Manual 2.) Enable Abnormality : IF ENABLE ABNORMALITY TO CHANGE ON FAIL 1. TO CHECK IC PIN9 TRUN Q201&Q202 NO HAVE 12 VOLTAGES PASS FUNCTION TEST OK! 3.) Dimming Control Abnormality : IF DIMMING ABNORMALITY TO TO CHANGE ON R201 OR CHECK R201&R202&R203 HAVR...
Page 35
HP f1703 Service Manual 4.) Transformer Abnormality : IF TRANSFORMER ABNORMALITY TO TO CHANGE ON FAIL CHECK C213&C214 CHIP OUTLINE OR C213&C214 OR TRANSFORMER TRANSFORMER PASS FUNCTION TEST OK! 5.) Instruments For Test: 1.DC POWER SUPPLY GPS-3306D 2.AC VTVM VT:-181E 3.DIGITAL MULTIMERTER...
HP f1703 Service Manual 8.2.3 KeyPad Board OSD is unstable or not working Connect KeyPad Board Is KeyPad Board connecting normally ? Replace Button Switch Is Button Switch normally ? Replace KeyPad Board Is KeyPad Board Normally ? Check Main Board 8.3 Alignment Procedure...
Monitor serial number (HP consumer format) xx, xx, xx, xx, xx, xx xx, xx, xx, xx, xx, xx Extension CheckSum (varies) Notes: 1. For reference only. Actual content to be approved by HP. 2. Coloreal data in Descriptor 4; no serial number encoding.
HP f1703 Service Manual 8.5 Serial Number Format: The serial number, as defined in Appendix A of label spec 308097, consists of 10 digits as follows: XXSDD0#### Where, XX = The two digit ISO country code for the country of origin (e.g. TW = Taiwan)
Page 41
HP f1703 Service Manual Level Location Number Specifacation Item Quantity Uni ------------------------------------------------------------------------------ 2 L902 73L 253 91 L CHOKE BY LI TA 0.00000 2 L902 73L 253 91 S CHOKE COIL 184 1.00000 2 T901 80L 600 3 L X'FMR BY LI TAI 0.00000...
Page 46
HP f1703 Service Manual Level Location Number Specifacation Item Quantity Uni ------------------------------------------------------------------------------ 40L 154501 1 LABELHI-POT GROUNDING LABEL 1.00000 40L416B690 1A ADAPTER ID LABEL 1.00000 45L 88525 E PE BAG 1.00000 W33L4477 B T TOP COVER 1.00000 W33L4478 B T BOTTOM COVER 1.00000...