Advertisement
Quick Links
Jack Mount Kit
TimeCutter
Model No. 147-8836
Safety
Safety and Instructional
Decals
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
127-6663
1. Warning—read the
Operator's Manual.
© 2023—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mower
decal127-6663
2. Crushing hazard—engage
the parking brake, shut off
the engine, and remove
the key; support the
machine using jackstands.
Register at www.Toro.com.
Installation
Determine the left and right sides of the machine from
the normal operating position.
Preparing the Machine
Gas Models Only
1.
Park the machine on a level surface.
2.
Disengage the blade-control switch.
3.
Move the motion-control levers outward to the
P
position.
ARK
4.
Shut off the machine and remove the key.
5.
Wait for all moving parts to stop.
Electric Models Only
1.
Park the machine on a level surface.
2.
Disengage the blade-control switch.
3.
Move the motion-control levers outward to the
position.
NEUTRAL
4.
Engage the parking brake.
5.
Shut off the machine and remove the key.
6.
Wait for all moving parts to stop.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3465-943 Rev A
Installation Instructions
*3465-943*
Advertisement
Related Manuals for Toro TimeCutter 147-8836
Summary of Contents for Toro TimeCutter 147-8836
- Page 1 Shut off the machine and remove the key. the key; support the Wait for all moving parts to stop. machine using jackstands. *3465-943* © 2023—The Toro® Company Original Instructions (EN) Register at www.Toro.com. 8111 Lyndale Avenue South Printed in the USA...
- Page 2 Installing the Jack Mount Operation Secure the jack mount to the left axle tube on the front of the machine using 2 U-bolts and 4 Using the Jack Mount locknuts (Figure WARNING The machine could fall onto someone and cause serious injury or death. •...
- Page 3 g467171 Figure 2 1. Jack pin 2. Jack Use the jack to raise the machine to the desired height. WARNING Raising the machine could cause a fuel leak. • Check for any fuel leaks before performing maintenance. • If you see a fuel leak, immediately lower the machine and do not attempt to start the engine.