Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................5 3. INSTALLATION....................6 4. PRODUCT DESCRIPTION................6 5.
Page 3
• Keep children and pets away from the appliance when it operates. • Children shall not carry out cleaning and user maintenance of the appliance without supervision. 1.2 General Safety • This appliance is intended for domestic use above hobs, cookers and similar cooking devices.
Page 4
• Make sure that the ventilation openings are not blocked and the air collected by the appliance is not conveyed into a duct used to exhaust smoke and steam from other appliances (central heating systems, thermosiphons, water- heaters, etc.). • When the appliance operates with other appliances the maximum vacuum generated in the room should not exceed 0.04 mbar.
2. SAFETY INSTRUCTIONS 2.1 Installation • Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable can make the terminal WARNING! become too hot. Risk of injury, electric shock, fire, burns • Connect the appliance at the end of the or damage to the appliance.
2.5 Disposal • Disconnect the appliance from the mains supply. • Cut off the mains electrical cable close to WARNING! the appliance and dispose of it. Risk of injury or suffocation. • Contact your municipal authority for information on how to dispose of the appliance.
2. If needed, change the speed by pressing the desired button. While heating up food, cooking with covered pots. Deactivating the appliance While cooking with covered pots on multiple cooking zones or burners, gentle frying. To turn off the appliance press the first speed While boiling and frying big quantities of food button again.
Page 8
6.2 Cleaning the grease filter Filters are mounted with the use of clips and pins on the opposite side. To clean the filter: 1. Press the handle of the mounting clip on the filter panel underneath the hood (1). To mount the filters back follow the steps in reverse order.
3. Mount the lamp cover. 7. TROUBLESHOOTING WARNING! Refer to Safety chapters. 7.1 What to do if... Problem Possible cause Remedy You cannot activate the appliance. The appliance is not connected to a Check if the appliance is correctly power supply or it is connected in‐ connected to the electrical supply.