Miele K 12820 SD edt Operating And Installation Manual
Refrigerator with dynamic cooling
Hide thumbs
Also See for K 12820 SD edt:
- Operating and installation instructions (44 pages) ,
- Operating and installation instructions (48 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele K 12820 SD edt
Summary of Contents for Miele K 12820 SD edt
- Page 1 Operating and installation instructions Refrigerator with Dynamic cooling K 11820 SD K 12820 SD K 12820 SD edt/cs en - GB To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Contents Guide to the appliance ..........4 Caring for the environment . - Page 3 Contents Installation ............36 Side-by-side installation.
-
Page 4: Guide To The Appliance
Guide to the appliance On/Off button Super cool button and indicator light Temperature selector button Dynamic cooling button and Temperature display indicator light... - Page 5 Guide to the appliance Dynamic cooling fan Butter and cheese compartment Egg tray Adjustable shelves Bottle rack Bottle shelf Condensate channel and drain hole Fruit and vegetable containers...
-
Page 6: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 7: Warning And Safety Instructions
They contain important information on its safety, installation, use and maintenance. Miele cannot be held liable for damage caused by non-compliance with these Warning and Safety instructions. - Page 8 The appliance is not suitable for use in areas where there is a risk of explosion. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The appliance can only be used by people with reduced...
- Page 9 Warning and Safety instructions Danger of suffocation. Packaging, e.g. cling film, polystyrene and plastic wrappings, must be kept out of the reach of babies and children. Whilst playing, children could become entangled in packaging or pull it over their head and suffocate. Technical safety The coolant system is tested for leaks.
- Page 10 If the electrical connection cable is faulty it must only be replaced by a Miele approved service technician to protect the user from danger. Do not connect the appliance to the mains electricity supply by a multi-socket adaptor or extension lead .
- Page 11 The manufacturer can only guarantee the safety of the appliance when original Miele replacement parts are used. Faulty components must only be replaced by genuine Miele original spare parts. In areas which may be subject to infestation by cockroaches or other vermin, pay particular attention to keeping the appliance and its surroundings clean at all times.
- Page 12 Only use genuine original Miele accessories with this appliance. Using spare parts or accessories from other manufacturers will invalidate the guarantee, and Miele cannot accept liability.
- Page 13 Warning and Safety instructions Stainless steel appliances Do not use sticky notes, transparent adhesive tape, masking tape or other types of adhesive on the surface of the door. These damage the surface, causing it to lose its dirt-repellent protective coating. The high-quality surface of the door is susceptible to scratching.
- Page 14 Warning and Safety instructions Disposal of your old appliance Before disposing of an old appliance, first make the door latch or lock unusable. This way you will prevent children from accidentally locking themselves in and endangering their lives. Be careful not to damage any part of the pipework whilst awaiting disposal, e.g.
-
Page 15: How To Save Energy
How to save energy Normal energy Increased energy consumption consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct In direct sunlight. sunlight. Not near to a heat source Near to a heat source (radiator, oven). (radiator, oven). - Page 16 How to save energy Normal energy consumption Increased energy consumption Drawers, shelves and racks arranged as they were when the appliance was delivered. Only open the doors when Frequent opening of the door necessary and for as short a for long periods will cause a time as possible.
-
Page 17: Switching On And Off
Switching on and off Before using for the first time Switching off Important: To ensure the correct functioning of the appliance, let it stand for 1½ to 2 hours after transporting it to its final ^ Press the On/Off button until the location before connecting it to the temperature display goes out. -
Page 18: The Correct Temperature
The correct temperature . . . in the refrigerator It is very important to set the correct temperature for storing food in the We recommend a temperature of 5 °C appliance. Micro-organisms will cause in the middle of the refrigerator. food which is not stored at the correct temperature to deteriorate rapidly. -
Page 19: Temperature Display
The correct temperature Temperature display To set the temperature between 5 and 7 °C to be slightly colder: The temperature display on the ^ Press the temperature selector button control panel always shows the repeatedly until the indicator for 5 °C required temperature. -
Page 20: Super Cool And Dynamic Cooling
Super cool and Dynamic cooling Dynamic cooling m Super cool The Super cool function can be used to When the Dynamic cooling function is rapidly reduce the temperature in the not switched on, the natural circulation refrigerator section to its lowest setting of air in the appliance will cause (depending on the room temperature). - Page 21 Super cool and Dynamic cooling Switching off Dynamic cooling ^ Press the Dynamic cooling button m. The Dynamic cooling indicator light will go out. The fan automatically switches off when the door is open.
-
Page 22: Storing Food In The Refrigerator
Storing food in the refrigerator Different storage zones Warmest area Due to the natural circulation of the air The warmest area is in the top section in the appliance, there are different at the front and in the door. Use this for temperature zones in the refrigerator. -
Page 23: Food Which Is Not Suitable For Storing In The Refrigerator
Storing food in the refrigerator Food which is not suitable for Do not store explosive materials in storing in the refrigerator the appliance or any products Not all food is suitable for storing in a containing propellants (e.g. spray refrigerator at temperatures below 5 °C, cans). -
Page 24: When Shopping For Food
Storing food in the refrigerator When shopping for food Storing food correctly The freshness of food when first placed Food should generally be stored in the appliance is an important factor covered or packaged. This will prevent in determining how long it stays fresh, food smells from affecting other food, and how long it can be kept in the food from drying out, and also any... -
Page 25: Adjusting The Interior Fittings
Adjusting the interior fittings Moving the shelves The shelves can be adjusted according to the height of the food. ^ Raise the shelf, and pull it forwards slightly until the notch at the side is in line with the shelf support. It can then be raised or lowered to the required level. - Page 26 Adjusting the interior fittings Fruit and vegetable containers The fruit and vegetable containers are pushed in and out on telescopic runners, and can be completely removed if necessary. ^ Pull the container right out and then lift it up and off. Push the runners back in again to avoid injury or damage.
-
Page 27: Automatic Defrost
Automatic defrost The refrigerator defrosts automatically. Condensate and frost can build up on the back wall of the refrigerator whilst it is in use. You do not need to remove this, as it will defrost and evaporate automatically with the warmth generated by the appliance. -
Page 28: Cleaning And Care
Cleaning and care To avoid damaging the surface of A range of Miele branded cleaning your appliance, do not use: and conditioning products is – cleaning agents containing soda, available to order from Miele (see ammonia, acids or chlorides, back cover for contact details). -
Page 29: Cleaning The Interior And Accessories
Cleaning and care ^ After cleaning, wipe the interior and Cleaning the interior and accessories with a damp cloth and accessories dry with a soft cloth. ^ Clean the appliance at least once a Leave the door open to air the month. -
Page 30: Ventilation Gaps
– stainless steel cleaning agent: appliance. this will damage the surface. – Miele stainless steel conditioning When cleaning make sure that the agent: cable and other components do not this will cause noticeable smearing. -
Page 31: Problem Solving Guide
^ Check that the plug is correctly lighting is defective. inserted into the socket and switched ^ Call Miele Service. The LED lighting may only be repaired ^ Check that the mains fuse has not or replaced by a service technician. - Page 32 ^ Clean the condensate channel and drain hole. If you still cannot remedy the fault having followed these suggestions, please contact Miele Service. To prevent unnecessary loss of temperature it is advisable not to open the door while waiting for the...
-
Page 33: Noises
Noises Normal noises What causes them Humming noise made by the motor (compressor). This noise can Brrrrr... get louder for brief periods when the motor is switching on. Blubb, blubb..A gurgling noise can be heard when coolant is circulating through the pipes. -
Page 34: After Sales / Guarantee
– your Miele Dealer – Miele (see back cover for contact details). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. This information is given on the data plate inside your appliance. -
Page 35: Electrical Connection
Electrical connection Electrical connection U.K. If the connection cable has to be replaced, this must be done by a All electrical work should be carried out suitably qualified and competent by a suitably qualified and competent person. person in strict accordance with current local and national safety regulations Do not plug other appliances in behind (BS 7671 in the UK). -
Page 36: Installation
Installation – The plug and cable must not touch Do not place any appliance which the rear of the appliance as they gives off heat, such as a toaster or could be damaged by vibrations microwave oven, on top of this from the appliance. -
Page 37: Climate Range
Installation Aligning the appliance Climate range The appliance is designed for use within certain climate ranges (ambient temperatures), and should not be used outside this range. The climate range of the appliance is stated on the data plate. Climate range Ambient room temperature +10 °C to +32 °C... -
Page 38: Appliance Dimensions
Installation Appliance dimensions K 11820 SD, K 12820 SD, 1 850 mm 600 mm 630 mm K 12820 SD edt/cs... -
Page 39: Changing The Door Hinging
Changing the door hinging The appliance is supplied right-hand Removing the door handle hinged. If left-hand door hinging is required, follow the instructions below. To change the door hinging you will need the following tools: Two people are needed for changing the door hinging. - Page 40 Changing the door hinging ^ Then separate retaining plate Changing over the door from cover , by pushing it slightly to the Make sure the door shelves are left and then pulling the cover empty! forwards and off. ^ Rotate retaining plate by 180°.
- Page 41 Changing the door hinging ^ Pull hinge pin together with disc and adjustable foot upwards and off. ^ Remove cover cap ^ Undo screws and take hinge plate ^ Remove cap from the bearing off. bush in the door and refit on the ^ Undo the screw of hinge part opposite side.
- Page 42 Changing the door hinging ^ Screw hinge plate into position on ^ Fit hinge plate onto the opposite the opposite side using the two outer side and secure it with screws long slots only. To make it possible to ^ Fit covers to their opposite align the door later, do not replace sides.
- Page 43 Changing the door hinging Refitting the handle It is important to check that the side Please make sure you follow the section of the handle does not instructions below carefully when come into contact with the door seal you refit the handle. The door seal when opening the door, as this will be damaged if the handle is would damage the door seal...
-
Page 44: Aligning The Appliance Door
Aligning the appliance door The appliance door can be aligned to the housing using the outer long slots in the lower hinge plate. In the following illustration the door is not shown in the closed position to make it easier to see what you have to do. -
Page 45: Building In The Appliance
Building in the appliance The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. When built into a kitchen run (max. depth 580 mm) the appliance can be installed directly next to a kitchen furniture housing unit. - Page 48 Alteration rights reserved / 4912 M.-Nr. 09 434 270 / 00 K 11820 SD, K 12820 SD, K 12820 SD edt/cs...