2.3.2 Voltage range 2.3.3 Overvoltage/undervoltage 2.3.4 Power supply cable 2.3.5 Input/output electrical characteristics defined for all external connections 2.3.6 Protection/on-board network connection 3. DESCRIPTION OF THE INTERFACES 3.1 LED Function 3.2 Connectors 4. TECHNICAL DATA Wavecom WMO2 Modem GUIDE 19/04/99, 9:20...
Page 3
5.2 The modem always returns «Error» when trying to issue a communication 5.3 The modem always returns «No carrier» when trying to issue a communication 6. NOTES ON SAFETY 6.1 General safety 6.2 Vehicle safety 6.3 Car And Maintenance 6.4 Your responsibility 7. GENERAL INFORMATIONS Wavecom WMO2 Modem GUIDE 19/04/99, 9:20...
- 1 User manual (this document) Product presentation The Wavecom WMO2 modem is a terminal for fax and data transmission, short message service mobile originated, short message service mobile terminated and voice calls. The connectors binded to the body guarantee output and input connections.
. e l o i t ( t i o i t Temperature range Operating conditions : From -20 C to +55 C Storage conditions From -25 C to +70 C Wavecom WMO2 Modem GUIDE 19/04/99, 9:20...
In order to extract or to insert the Micro SIM card, it is necessary to press the SIM holder ejector with a sharp element (a pen for example). If this sequence is not respected, the SIM holder could be damaged. Wavecom WMO2 Modem GUIDE 19/04/99, 9:21...
5 to 32V DC (GSM 900) - 6 to 32V DC (GSM 1800/1900) 2.3.3 Overvoltage/undervoltage Correct operation of the Wavecom WMO2 modem in communication mode is not guaranteed if input voltage fall below 5V (GSM 900) - 6V (GSM 1800/1900). The modem is protected against voltage over 32V.
24x0.2 mm Section 0.75 mm Stripped wire, tinned over 5 mm Cables stripped over 200 mm, protected by their own sheath Connector Molex Micro-Fit 3.0 Standard cable sheath Side view Figure 3 Power supply cable Wavecom WMO2 Modem GUIDE 19/04/99, 9:21...
2.3.5 Input/output electrical characteristics defined for all external connections o i t 2.3.6 Protection/on-board network connection The modem is protected by a fuse directly binded on the power supply cable. Wavecom WMO2 Modem GUIDE 19/04/99, 9:21...
Device switched on - Connecting to network - LED flashing slowly Device switched on - Idle mode - LED flashing rapidly Device switched on - Transmission mode Connectors n i l n i l t i s « » Wavecom WMO2 Modem GUIDE 19/04/99, 9:21...
- Insert the SIM card. - Check that it fits into place correctly. SIM card Extractible SIM card holder Figure 5 SIM card holder Yellow button to eject the holder (with a sharp element) Wavecom WMO2 Modem GUIDE 19/04/99, 9:21...
Page 12
Figure 6 15 pins SUB D connector (high density) i r r Pins assignment for 15 pins SUB D Connector ) - ( ) - ( Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
Page 13
Figure 7 4 pins Micro-Fit connector 4 pins Micro-Fit 3.0 can be ordered from a supplier called MOLEX. The address can be obtained on the following internet site : www.wavecom.com Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
The factory setting for baud rate is autobauding mode. D) Does any other program interfere with your communication program (conflict on communication port access)? If yes, close any application likely to interfere (e.g. mouse or printer driver). Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
Is the modem registered on the network? Does the AT-Command AT + CREG? answers 0,1 (registered) or 0,5 (registered roaming)? If not, check that the received signal is strong enough to synchronize on the Network (use AT+CSQ). Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
For all other codes, and/or details, see AT commands manual. Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
Page 18
Insure the selected bearer type is supported by the called party. Then, insure the selected bearer type is supported by the Network. If no success, try bearer selection type: AT+CBST=0,0,3. Insure the SIM Card is available for Data/Fax calls. Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
Consult the manufactures of the medical device to determine if it is adequately protected. Operation of your GSM Modem close to other electronic equipment may also cause interference if the equipment is inadequately protected. Observe any warning signs and manufacturers recommendations. Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
Do not abuse your GSM Modem by dropping, knocking, or violent shaking. Rough handling can damage it. Do not place the GSM Modem alongside computer discs, credit or travel cards or other magnetic media. The information contained on discs or cards may be affected by the phone. Wavecom WMO2 Modem GUIDE 19/04/99, 9:22...
The use of third party equipment or accessories, not made or authorized by Wavecom may invalidate the warranty of GSM Modem. Do contact an authorized Service Center in the unlikely event of a fault. Your Responsibility This GSM Modem is under your responsibility. Please treat it with care respecting all local regulations. It is not a toy therefore keep it in a safe place at all times and out of the reach of children.
Some mentioned products are registred trademarks of them respective companies. Copyright This manual is copyrighted by Wavecom with all rights reserved. No part of this manual may be reproduced in any form without the prior written permission of Wavecom. No patent liability is assumed with respect to the use of the information contained herein.
Page 23
Tel: +33 1 46 29 08 00 - Fax: +33 1 46 29 08 08 WAVECOM Inc. - 5405 Morehouse Drive, Suite 330 - San Diego, CA 92121 - USA Tel: +1 619 450 1778 - Fax: +1 619 450 1636 WAVECOM Asia Pacific Ltd.