Advertisement
IA
WARNING
l
ALL RANGES CAN
TIP
. INJURY TO PERSONS
COULD RESULT
. INSTALL ANTI-TIP
DEVICE PACKED
WITH RANGE
. SEE INSTALLATION
INSTRUCTIONS
IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer:
Leave Installation
Instructions
with the homeowner.
Homeowner:
Keep installation
instructions
for future reference.
Save Installation
Instructions
for local
electrical
inspector's
use.
Part No. 3 16002942/437 1893
Advertisement
Table of Contents
Related Manuals for Whirlpool 316002942
Summary of Contents for Whirlpool 316002942
- Page 1 WARNING ALL RANGES CAN . INJURY TO PERSONS COULD RESULT . INSTALL ANTI-TIP DEVICE PACKED WITH RANGE . SEE INSTALLATION INSTRUCTIONS Part No. 3 16002942/437 1893 IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep installation instructions...
-
Page 2: What To Do If You Smell Gas
Before you start... * Note: 30” min. when bottom Important: Observe Electrical and gas dimensions wood or metal cabinet governing codes Proper installation is your responsibility. protected by not less than l/4” Shaded area is flame retardant millboard qualified technician must install this range. -
Page 3: Electrical Requirements
Recommended Provide a gas supply line of 3/4” rigid grounding method pipe to the range location. -A smaller size- pipe on long runs may result in insufficient DO NOT, UNDER ANY CIRCUMSTANCES, Property Damage gas supply. Pipe-joint compounds made REMOVE THE POWER SUPPLY CORD use with L.P. -
Page 4: Gas Conversion
blue flame. To adjust the burner, remove w Push in and turn the control knob and turn the adjustment screw control knob to the “LITE” position in the center of the valve stem. Check and then to the “LO” position. adjustment by turning the control knob from... - Page 5 Oven thermostat adjustment For cleaning and w Convert surface burner valves, (all models). Standing Pilot System only maintenance... Lift and lock If your range is connected to natural gas, cooktop in up the selector should be turned so the If removing the range is necessary position.