Metal Part cal return path to the chassis. Any current measured must not exceed 0.5mA. Reverse the instrument power cord plug in the out- ohmmeter let and repeat the test. See Fig. 1-1. Fig. 1-2 Insulation Resistance Test Samsung Electronics...
Page 3
(5) antenna wiring. Always inspect in all areas tinuously and new instructions are issued whenev- for pinched, out-of-place, or frayed wiring, Do not er appropriate. change spacing between a component and the printed-circuit board. Check the AC power cord for damage. Samsung Electronics...
Components identi- fied by shading, by( ) or by ( ) in the circuit dia- gram are important for safety or for the characteris- tics of the unit. Always replace them with the exact replacement components. Samsung Electronics...
Page 5
(6) Do not remove a replacement ESD device from its protective package until immediately before your are ready to install it.(Most replacement ESD devices are packaged with leads electrically short- ed together by conductive foam, aluminum foil or comparable conductive materials). Samsung Electronics...
Page 6
◆ Be sure to put on a wrist strap grounded to the sheet. ◆ Be sure to lay a conductive sheet made of copper etc. Which is grounded to the table. Samsung Electronics...
Page 7
3) Make solder land 3 points short on Pick-up FPC. (See Fig. 1-4) 4) Disassemble the Pick-up. Note : If the assembly and disassembly are not done in correct sequence, the Pick-up may be damaged. ASS'Y-DVD DECK FPC (Bottom View) SOLDER LAND 3 POINTS SHORT Fig. 1-4 Samsung Electronics...
VIC01 (MM1566) 6dB Amp CVBS Out/In Switch SIC3 (FAN8728) XTC02/03 Motor Drive ZIC2 (NT5SV4M16DT) SIC01 (SAA7114) (74LVX573) 64MBit SDRAM Video Decoder XTC01 U1 (LWT13611) Jag-D Timing Controller Display Scaler Samsung Electronics This Document can not be used without Samsung’s authorization...
Page 33
Block Diagram MEMO This Document can not be used without Samsung’s authorization Samsung Electronics...