Page 3
3 RECOMMENDATIONS AND SUGGE- STIONS CHARACTERISTICS MAINTENANCE...
Page 4
Thank you for choosing a fi rst class product from Electrolux, which hopeful- ly will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality prod- ucts that make your life more comfort- able.
6 electrolux Recommendations and Suggestions RECOMMENDATIONS AND SUGGESTIONS Installation • Adjust the fl ame intensity to direct it onto the bottom of the pan only, mak- • The manufacturer will not be held li- ing sure that it does not engulf the able for any damages resulting from sides.
Page 9
9 Installation INSTALLATION Drilling the Ceiling/shelf • Use a plumb line to mark the centre of the hob on the ceiling/support shelf. • Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob.
Page 10
10 electrolux Installation Fixing the frame • Loosen the two screws fastening the lower chimney and remove this from the lower frame. • Loosen the two screws fastening the upper chimney and remove this from the upper frame. If you wish to adjust the height of the frame, proceed as follows: •...
Page 11
11 Installation Connection in Ducting Version When installing the ducting version, ø 150 ø 120 connect the hood to the chimney using either a fl exible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer.
12 electrolux Installation / Use Electrical Connection • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. • Remove the grease fi lters (see para- graph Maintenance) being sure that...
Page 13
13 Touch Basic functions Indicator lights control Dual Function When briefl y pressed it switches the lighting Touch control Lights off system on and off. unlit When pressed for 2 seconds it starts the Touch control lit Lights on lighting system in “courtesy light”...
14 electrolux Maintenance MAINTENANCE Cleaning the Comfort Panels Cleaning of the Metal Cassette Filters • Pull the Comfort Panel to open it. • Disconnect the panel from the hood Alarm reset canopy by sliding the fi xing pin lever. • Stop the motor.
Page 15
15 Maintenance Replacing the Charcoal Filter Reset the alarm signal • Stop the motor. This fi lter cannot be washed or regene- • Press the touch control F for at least rated, and must be replaced when the F 4 seconds, until the touch control T1 touch control starts to fl...