Page 1
To obtain the best performance, please read this instruction manual completely. Arahan pengendalian Muka surat 21~40 Untuk mendapatkan prestasi yang tinggi, sila baca arahan ini sepenuhnya. – 1 – (EN1) RAS-E10CZ.indd 1 (EN1) RAS-E10CZ.indd 1 5/7/10 10:54 AM 5/7/10 10:54 AM...
Do not use any conductor as fuse wire, this could cause fatal accident. ● During thunder storm, disconnect and turn off the circuit breaker. ● – 2 – (EN1) RAS-E10CZ.indd 2 (EN1) RAS-E10CZ.indd 2 5/7/10 10:54 AM 5/7/10 10:54 AM...
Page 3
Young children should be supervised to ensure that they do not play with the appliance. ● – 3 – (EN1) RAS-E10CZ.indd 3 (EN1) RAS-E10CZ.indd 3 5/7/10 10:54 AM 5/7/10 10:54 AM...
Connecting cord and insulation pipe for piping Air inlet (Back side) Air outlet MODEL NAME AND DIMENSIONS MODEL WIDTH (mm) HEIGHT (mm) DEPTH (mm) RAS-E10CZ RAC-E10CZ – 4 – (EN1) RAS-E10CZ.indd 4 (EN1) RAS-E10CZ.indd 4 5/7/10 10:54 AM 5/7/10 10:54 AM...
Press again the temporary switch to cancel the force cooling operation. ● Do not operate in this mode for more than 5 minutes. ● * To be conduct by authorised personel only. – 5 – (EN1) RAS-E10CZ.indd 5 (EN1) RAS-E10CZ.indd 5 5/7/10 10:54 AM 5/7/10 10:54 AM...
This is to protect the device and does not indicate a failure. If you press the FUNCTION selector button during operation, ● the device may stop for about 3 minutes for protection. – 6 – (EN1) RAS-E10CZ.indd 6 (EN1) RAS-E10CZ.indd 6 5/7/10 10:54 AM 5/7/10 10:54 AM...
(STOP) button to stop operation. STOP ■ As the settings are stored in memory in the remote controller, you only have to press the (COOLING) button next time. – 7 – (EN1) RAS-E10CZ.indd 7 (EN1) RAS-E10CZ.indd 7 5/7/10 10:54 AM 5/7/10 10:54 AM...
The function will stop (the indoor unit will stop emitting air) as soon as the room temperature becomes lower than the setting temperature. You might feel a bit colder in dehumidifying operation. – 8 – (EN1) RAS-E10CZ.indd 8 (EN1) RAS-E10CZ.indd 8 5/7/10 10:54 AM...
During circulation operation, compressor will not be running and there is no cooling operation with only ● indoor fan running. When the setting temperature is higher than room temperature, indoor fan will stop running. ● – 9 – (EN1) RAS-E10CZ.indd 9 (EN1) RAS-E10CZ.indd 9 5/7/10 10:54 AM 5/7/10 10:54 AM...
Page 10
After sleep timer time is up and when press sleep button again, the sleep ● timer will be set as last setting. Sleep timer effective only once. ● – 10 – (EN1) RAS-E10CZ.indd 10 (EN1) RAS-E10CZ.indd 10 5/7/10 10:54 AM 5/7/10 10:54 AM...
Select the ON TIMER by pressing the (ON) temperature). ● Button. Setting time will change according to the below ● sequence. – 11 – (EN1) RAS-E10CZ.indd 11 (EN1) RAS-E10CZ.indd 11 5/7/10 10:54 AM 5/7/10 10:54 AM...
2. Take out the batteries when you do not use the remote controller for 2 or 3 months. 3. Use high quality and high performance AAA batteries to avoid short operating life and electrolyte leakages – 13 – (EN1) RAS-E10CZ.indd 13 (EN1) RAS-E10CZ.indd 13 5/7/10 10:54 AM 5/7/10 10:54 AM...
Page 14
fi lter every and air fl ow direction when operating the unit 2 weeks. for baby, children and old folks who have diffi culty in movement. – 14 – (EN2) RAS-E10CZ.indd 14 (EN2) RAS-E10CZ.indd 14 5/7/10 9:13 AM 5/7/10 9:13 AM...
Page 15
Interference From Electrical Products Caution To avoid noise interference, please place the indoor unit and its remote controller at least 1m away from electrical products. – 15 – (EN2) RAS-E10CZ.indd 15 (EN2) RAS-E10CZ.indd 15 5/7/10 9:13 AM 5/7/10 9:13 AM...
The fi lter may shrink. Do not use detergent on the air cleansing fi lter as some detergent may deteriorate the fi lter ● electrostatic performance. – 16 – (EN2) RAS-E10CZ.indd 16 (EN2) RAS-E10CZ.indd 16 5/7/10 9:13 AM 5/7/10 9:13 AM...
CAUTION Never use hot water (above 40°C), benzine, gasoline, acid, thinner ● or a brush, because they will damage the plastic surface and the coating. – 17 – (EN2) RAS-E10CZ.indd 17 (EN2) RAS-E10CZ.indd 17 5/7/10 9:13 AM 5/7/10 9:13 AM...
Is the mounting frame seriously affected by rust and is the outdoor unit tilted or unstable? Is the plug of power line fi rmly plugged into the socket? (Please ensure no loose contact between them). – 18 – (EN2) RAS-E10CZ.indd 18 (EN2) RAS-E10CZ.indd 18 5/7/10 9:13 AM 5/7/10 9:13 AM...
Page 19
Power supply shall be connected at the rated voltage, otherwise the unit will be broken or could not reach ● the specifi ed capacity. – 19 – (EN2) RAS-E10CZ.indd 19 (EN2) RAS-E10CZ.indd 19 5/7/10 9:13 AM 5/7/10 9:13 AM...