Page 1
i ° Quick Reference Table of Contents: Pages Before vou start Product dimensions Cabinet dimensions/requirements Electrical requirements Installation steps Check operation If range does not operate If you need assistance service Moving the range mfyou need assistance: Check your Use and Care Guide for a toll-free number to call or call the dealer from whom you purchased...
shown must be used. Given dimensions Before you start,,, are minimum clearances. Grounded electrical outlet is required. Your safety and the safety of See "Electrical requirements[' Page 4. others are very important, level flat-blade screwdriver We have provided many important 3/8"...
Page 3
46-13/!6" overall height i"_,_ 26-3/8" depth with 36" handle cooktop height 30" width 24-I/2" Cabinet opening dimensions shown are for: 25" eountertop depth, 24" base cabinet depth, _.r_i']_ 36" countertop height clearance to r;ofihe J J J- _ ' coo!<tOp,, s ee __pening NOTE,":": "_'-...
if codes permit and a separate ground Range must be connected to the proper If connecting to a four-wire wire is used, it is recommended that a electrical voltage and frequency as system: qualified electrician determine that the specified on the model/serial rating plate. This range is manufactured with the ground path and wire gauge are in (The model/serial rating plate is located...
Page 5
ow start... EJectdcaJ connection Excessive Weight Hazard Use two or more people to move and Tip Over Hazard ,'olm//\ ,/ install range. A child or adult ¢an tip the range and Failure to do so can result in back or be killed.
Page 6
NOTE: Thebagcontaining t hree 10. Connect the neutral wire (center wire) easily attach the wiring to the terminal aluminum terminaU U ugs is notused block. to the center terminal screw on the when connecting therange using a terminal blocL See Figure 2. 5.
Page 7
NOTE:The bag containing three 8. Attach three aluminum terminal lugs 6 gauge aluminum wire, tighten to aluminum terminal lugs must be used to terminal posts. 35 in/Ibs of torque to make a proper when making a direct wire connection. electrical connection. See Figure 2. Use a 3/8"...
Page 8
Operating position M Move range close to cabinet opening. Remove cardboard or Place rack in oven. Place level hardboard from under range. Carefully on rack, first side to side; then front to move range into final position. back. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket.
Page 9
Check operation O O FRONT Check the operation of the cooktop elements: Push in and turn each surface unit control knob to "Hi" position. Check the operation of the cooktop elements and 4/5\6 [] Check the operation of the oven: OVEN CLOCK LIGHT...
Moving the range: if range does not mfyou need serv|ce: operate; [_ Check that the circuit breaker is Maintain the quality built into your range not tripped or the house fuse by ca[ling an authorized service blown. company. To obtain the name and number of the [_ Check that the power suppUy cord is pUugged into the outlet.