DANGER WARNING CALIFORNIA PROPOSITION 65 If you smell gas: 1. Combustion by-products produced when using this 1. Shut off gas to the appliance. product contain chemicals known to the State of 2. Extinguish any open flame. California to cause cancer, birth defects, and other reproductive harm.
GRILLING GUIDE – Getting Started Temperature The temperature gauge in the hood of your new grill measures air temperature. The air temperature inside your First Time Use grill will never be as hot as the temperature at the cooking Read your Assembly Manual and ensure the grill is put surface.
Page 5
Rotisserie Cooking GRILLING GUIDE – Grilling 101 Rotisserie cooking is best for 'round' meat, such as large roasts, whole poultry, and pork. It generally requires an Outdoor grilling is really quite simple. You'll succeed with accessory motor and spit rod that allows the meat to be burgers, dogs, or steaks usually on your very first try.
Page 6
Wood Chips GRILLING GUIDE – Tips & Tricks For extra smoke flavor when grilling, try adding wood Cooking on your new grill is a hands-on experience, and it chips. Soak the chips in water for approximately 30 is recommended to remain outside with your grill while minutes before adding to a smoke box or pan.
Cooking surfaces: If a bristle brush is used to clean any of GRILLING GUIDE – Cleaning Your Grill the grill cooking surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is not recommended to Why Clean? clean cooking surfaces while grill is hot.
LP Tank USE AND CARE • The LP Tank used with your grill must meet the following requirements: DANGER • Use LP Tanks only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum.
Page 9
LP Tank Exchange Connecting Regulator To The LP Tank • Many retailers that sell grills offer you the option of 1. LP tank must be properly secured onto grill. (Refer to replacing your empty LP tank through an exchange service. assembly section.) Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks.
Page 10
Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately.
Page 11
Safety Tips Before opening LP cylinder valve, check the coupling nut WARNING for tightness. When grill is not in use, turn off all control knobs and LP cylinder valve. For Safe Use of Your Grill and to Avoid Serious Never move grill while in operation or still hot. Use long-handled barbecue utensils and oven mitts to Injury: avoid burns and splatters.
Page 12
Burner Flame Check WARNING • Remove cooking grates and heat diffusers. Light burners, rotate knobs from HIGH to LOW. You should see a smaller flame in LOW position than seen on HIGH. Turn controls and gas source when not in use. Perform burner flame check on side burner, also.
4. Detach electrode from burner. CAUTION NOTE: Removal/Detachment method will depend on the burner configuration. See different configurations in illustrations below. 5. Carefully lift each burner up and away from valve SPIDER ALERT! openings. We suggest three ways to clean the burner tubes.
PARTS LIST Key Qty Description Part # Key Qty Description Part # BACK RAIL 3 HEAT DIFFUSER G314-0806-W1 G314-0303-W1 RIGHT LEG ASSEMBLY 2 COOKING GRATE G314-3800-W2 G314-0304-W1 LEFT LEG ASSEMBLY SWING AWAY GRATE G314-3700-W2 G314-0002-W1 MATCH HOLDER CLIP, F/ GREASE CUP G401-0079-W1 G305-0043-W1 FRONT PANEL...
ASSEMBLY NOTE: DO NOT over tighten screws and washers that come into contact with porcelain coated surfaces. Over tightening may cause the porcelain coating to crack and break, resulting in exposed metal that will be prone to rust. Place rear rail between cart frames. Hook the key hole slots to the preassembled #10-24x1/2" machine screws.
Page 17
Hook the short tank exclusion wire(silver) onto front right leg. Flex tank exclusion wire to fit other end to the hole on bottom edge of rear rail. Front Right Leg Rear Rail Short Tank Exclusion (silver) Hook the long tank exclusion wire(black) onto front left leg. Flex tank exclusion wire to fit other end to rear right leg. Long Tank Exclusion (black) Rear Right Leg 466724112 •...
Page 18
This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart. Make sure the regulator hose is hanging inside the cart. Slide grill head from rear to front of cart until the pre-installed screws slide into the opening of the metal tabs. Tighten the pre-installed screws Grill Head...
Page 19
Slide keyhole slots in the left side shelf over the five pre-installed screws on the left side of the firebox (A). Tighten the pre-installed screws (B). Remove the nut from injector, insert the injector to the hole on the side burner brace, re-install and tighten the nut to fix the injector to side burner brace (C).
Page 20
Place heat diffusers over burners by inserting tabs into slots in front of firebox. Opposite ends of heat diffusers rest on pins in back of firebox. Place cooking grates onto grate rests. Insert ends of Swing Away pivot wire into holes in sides of grill lid. Insert ends of Swing Away leg wire into holes in sides of firebox.
Page 21
Hang grease cup clip from bottom of firebox and place grease cup into grease clip. Grease Cup Clip Grease Cup CAUTION Failure to install grease cup clip and cup will cause hot grease to drip from bottom of grill with risk of fire or property damage. Insert tank retainer wire into left legs.
Page 22
Set bottom of tank into notches of tank bracket (A). Tank collar opening must face to front of grill, lean tank inward and engage tank collar with tank wire (B). LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to grill and regulator (see Use &...
DANGER: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from •Damaged hose. •Turn off gas at LP cylinder or at source on natural gas systems. If cracked/cut/burned anything but burned, replace valve/hose/regulator.
Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light PIEZO PUSH-BUTTON AND ROTARY: using ignitor. • Push-button sticks at bottom. • Replace ignitor. • Rotary knob rotates without clicking. • Replace knob. • Sparking between ignitor and electrode. • Inspect wire insulation and proper connection. Replace wires if insulation is broken.