hit counter code
D-Link DCM-604 User Manual
  1. Manuals
  2. Brands
  3. D-Link Manuals
  4. Modem
  5. DCM-604 Series
  6. User manual
D-Link DCM-604 User Manual

D-Link DCM-604 User Manual

Rear panel and hardware connection
Hide thumbs Also See for DCM-604:
1
2
3
4
5
6

Advertisement

Table of Contents

See also: User Manual

Rear Panel and Hardware Connection

This chapter describes the proper steps for connecting your cable modem. Please
be sure to follow
the steps in the sequence outlined below. Failure to do so could result in improper
operation or failure
of your cable modem.
Step 1:
Connect a cable by feeding the F-connector on the back of the cable modem.
Ensure the center
conductor of the 75 ohm coaxial cable is inserted directly into the center of the F-
connector. Secure
the coaxial cable by carefully threading the outer shell of the coaxial cable connector
onto the
F-connector in a clockwise direction until tight. Be careful not to over-tighten the
connector or you may
damage either the connector or the cable modem.
Step2: Connect the cable modem to an IEEE 802.3 10BaseT / 802.3u 100Base-TX
Network using a
RJ-45 male-terminated Ethernet cable or an USB cable to the PC. This cable
modem equips with two
Ethernet ports, you can connect two PCs to the cable modem at the same time if
necessary.
Step 3: Connect the telephone sets to TEL1 and TEL2. Use RJ-11 telephone line to
connect
TEL1/TEL2 port on the cable modem and telephone socket on telephone.
Step 4: Connect the AC Adapter to the cable modem by inserting the barrel-shaped
connector into the
mating power connector on the back of the cable modem. Exercise carefully to
ensure the connectors
are properly aligned prior to insertion and ensure the two connectors engage
completely. The cable
modem is shipped with an AC adapter. Remember to use only power adapter that
came with the cable
modem. Other power adapters might have voltages that are not correct for your
particular cable

Advertisement

Table of Contents
loading

Related Manuals for D-Link DCM-604

Summary of Contents for D-Link DCM-604

  • Page 1 Rear Panel and Hardware Connection This chapter describes the proper steps for connecting your cable modem. Please be sure to follow the steps in the sequence outlined below. Failure to do so could result in improper operation or failure of your cable modem. Step 1: Connect a cable by feeding the F-connector on the back of the cable modem.

  • Page 2: Web Management

    modem. Using a power adapter with the wrong voltage can damage the cable modem. Step 5: Adjust the antenna if necessary. 5. Web Management For easy-changing the default setting or quick-checking diagnostics for troubleshooting, a Web-based GUI is built-in for your access. 5.1 Enter Modem's IP address Use the following procedures to login to your DCM-604.
  • Page 3 5.7 Wireless 5.7.1 Basic The Wireless Connection Status page allows configuration of the Access Point parameters including the SSID and channel number.
  • Page 4 5.7.2 Security This page allows configuration of the WEP keys and/or passphrase.
  • Page 5 5.7.3 Access Control This page allows configuration of the Access Control to the AP as well as on the connected clients.
  • Page 6 5.7.4 Advanced This page allows configuration of data rates and WiFi thresholds.

Table of Contents