10. Service technicians should remove their 16. Always connect a test instrument's ground watches while repairing an MWO. lead to the instrument chassis ground before connecting the positive lead; always remove the instrument's ground lead last. Samsung Electronics...
Page 3
PRECAUTION with the oven energized. DO NOT measure the voltage in the high voltage circuit Servicemen should remove their watches whenever including filament voltage of magnetron. working close to or replacing the magnetron. Samsung Electronics...
2. Specifications 2-1 Table of Specifications M1912 POWER SOURCE 230V 50Hz POWER CONSUMPTION 1,400W OUTPUT POWER 100W/1000W (IEC-705) OPERATING FREQUENCY 2450MHz TIMER 35 MINUTES COOLING METHOD COOLING FAN MOTOR MAGNETRON OM75S(31) OUTSIDE DIMENSIONS 517(W) x 297(D) x 379(H)mm OVEN CAVITY DIMENSIONS...
3. Operating Instructions 3-1 Control Panel Defrost Instant Reheat Open Door Push Button Samsung Electronics...
Page 6
3. Set the time to 4 to 5 minutes by turing TIMER knob. Important: If any problem is experienced in the operation of the oven, please refer to the section on page 4 "what to do if you are in doubt or have a problem." Samsung Electronics...
Operating Instruction 3-4 Variable Power Cooking Chart Operation: Set the COOKING POWER CONTROL knob OUTPUT POWER LEVEL to the appropriate power level by turning it. M1912 FULL 1000W HIGH 850W REHEAT 700W MEDIUM HIGH 600W MEDIUM 450W MEDIUM LOW 300W...
4-2 Replacement of High Voltage Transformer 1. Discharge the high voltage capacitor. 2. Disconnect all the leads. 3. Remove the mounting bolts. 4. Reconnect the leads correctly and firmly. H. V. Trans Screws Samsung Electronics...
• Insertion depth of the thin metal plate should be 0.5mm or less. 4-3-3 Removal of Key Door & Spring Remove pin hinge from Door "E" Detach spring from Door "E" and key door. Door "E" Key Door Spring Samsung Electronics...
8. Connect all the leads to the drive motor. Base Plate 9. Screw the deive motor cover to the base plate Drive Motor Cover with a screw driver. 10. Remount the coupler in the correct position. Samsung Electronics...
2. Isolate the magnetron from the circuit by disconnecting its leads. 3. A continuity check across the magnetron filament terminals should indicate one ohm or less. 4. A continuity check between each filament terminal and the magnetron case should read "open". Magnetron Samsung Electronics...
∞ Primary switch ∞ Monitor switch (COM-NC) 5. Confirm that the gap between the switch ∞ housing and the switch actuator is no more Monitor switch (COM-NO) ∞ than 0.5mm when door is closed. Secondary switch Samsung Electronics...
5. After heating for 2 minutes, measure the temperatures of water in Beaker each beaker. 6. Microwave heat distribution rate can be caicviated as follows : Minimum Temperature Rise Heat Distribution = X 100(%) Cooking Tray Maximum Temperature Rise The result should exceed 65%. Samsung Electronics...
Page 14
; CENTRAL SERVICE CENTER 5-11-2 At least once a year have the microwave energy survey meter checked for accuracy by its manufacturer. Samsung Electronics...
2) Defective con- The oven lamp does not light and fan motor Replace the timer. tacts of timer does not operate. NOTE: Interlock monitor switch must be replaced when the fuse is blown out. Samsung Electronics...
Page 16
3) Too small a If a small amount of food is heated repeatedly over To increase the oven load or no a long period of time, microwave turns off during load, place a glass of load operation. water into the oven. Samsung Electronics...
1) If there is no continuity in forward, direction the H.V.Diode is open. Replace. 2) If there is continuity in reverse direction, it's shorted. Fan motor Fan motor Check if the motor coil is open. Replace. does not rotate. Samsung Electronics...
MONITOR FUSE(1.6A) H. V. D RESISTOR SECONDARY TIMER S/W VPC S/W INRUSH RELAY SECONDARY MONITOR PRIMARY High Voltage Circuit MAGNETRON HIGH VOLTAGE DIODE TO CHASSIS HIGH VOLTAGE CAPACITOR H.V.FUSE SYMBOL COLOR BROWN BLACK BLUE ORANGE HIGH VOLTAGE TRANSFORMER Samsung Electronics...