Refer to the List of Video Cassette Recorder Terms on page 49 if you need an explanation for any terms in this manual Lithium Battery-CR 2032- Unpack the box and place the VCR on a flat, stable surface. RF Cable Infrared Remote Control Unit...
Page 10
plug&play setup Plug&Play Setup Start Plug&Play Setup before you start Check that the note connection is completed Tune the TV to your what will happen? Video Channel or to its AV mode NOTE: Load the batteries into the Remote Control Refer to the Remote Control diagram on pages 6–7...
Select the vacant position 52 on you TV. The TV set must be turned on Press o button on the Remote Control to enter the standby mode. Press and hold or on the VCR for more than 3 seconds.
Page 15
initial settings if you are using both the rf cable and Press 21-pin SCART cable for connection or to set the Video Channel to if you are using only the rf cable for RF CHANNEL 52 Press or to set the Video connection Channel to a vacant position between 22 and 68 which is not occupied by any station in your area...
Page 24
VCR. Insert the cassette as shown in the diagram below; Turn the TV on don’t use too much force. If the VCR was turned off before you inserted the cassette, the power will come on automatically.
Page 45
The VCR stops playback, rewinds the tape and ejects the cassette, then enters the standby mode automatically. No. It stops automatically after 5 minutes to protect the heads. This is normal. No, it is normal. This is normal. subsidiary information This is normal. It reduces distortion at the pause and resume points.