Related Manuals for Kenmore 3948597B
Summary of Contents for Kenmore 3948597B
- Page 1 Coin-Operated Automatic Washer ('_,I l>=J _jl+]j _>,, =H_, _,i ,, % 3948597B Sears Roebuck ® Commercial II:'_ and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com...
-
Page 2: Table Of Contents
For Sears warranty information or to contact a Sears Service Center, call 1-800-4-MY HOME sM(1-800-469-4663). If you need SERVICE or PARTS for your Kenmore coin- operated washer When requesting service, be ready to give the model number, serial number (located on a plate under the lid) and date of purchase. -
Page 3: Installation Requirements
WARNING: To reduce the risk of fire, electric shock, or injuryto persons when using the washer, follow basic precautions, including the following: • Read all instructions before using the washer. • Do not wash articles that have been previously cleaned in, washed in, soaked in, or spotted with... -
Page 4: Location Requirements
The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 39 in. (99 cm) above the floor and no higher than 96 in. (244 cm) from the bottom of the washer. Floor drain system (view 2) The floor drain system requires a siphon break that may be purchased separately. -
Page 5: Installation Instructions
It is recommended circuit serving only this appliance be provided. • This washer is equipped with a power supply cord having a 3 prong ground plug. • To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, ground-type in accordance with local codes and ordinances. -
Page 6: Remove Shipping Strap
Put hooked end of drain hose into laundry tub or standpipe. Rotate hook to eliminate kinks. To prevent drain water from going back into the washer: • Do not straighten hooked end of drain hose. Do not force excess drain hose into standpipe. Hose should be secure, but loose enough to provide a gap of air. -
Page 7: Connect The Inlet Hoses
NOTE: Do not overtighten. Damage to the valves can result. Check for leaks 8. Turn on the water faucets and check for leaks. A small amount of water might enter the washer. You will drain this later. NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. -
Page 8: Level The Washer
Install the front leveling feet 1. Prop up the front of the washer about 4 in. (10.2 cm) with a wood block or similar object. The block needs to support the weight of the washer. 2. Screw the lock nut onto each foot to within 1 in. (2.5 cm) of the base. -
Page 9: Adjusting Timer Clutch
NORMAL Cycle. To check the cycle, push the coin slide all the way in and pull all the way out. Note the wash cycle time. If the washer does not start or does not provide the proper wash time, the clutch assembly may need adjustment. -
Page 10: Changing Vend Price
Pull console forward then tilt it back. Remove washer cabinet clip on right side under console. Use screwdriver blade as shown. NOTE: For additional security, top can be locked to washer with a lock and key in the hole provided. Screw type lock available from industry sources. -
Page 11: Washer Use
10. Plug in washer or reconnect power. NOTE: Refer to the product information sheet provided with the coin box for additional information. WASHER USE Never place items in the washer that are dampened with gasoline or other flammable fluids. No washer can completely remove oil. -
Page 12: Kenmore Energy-Saving Feature
6 pair shorts 2 boy's shirts 2 blouses 6 handkerchiefs This washer provides all cold water rinses. Laboratory analysis indicates no rinse problems with either phosphate or powdered non-phosphate detergents. Modern fabrics (synthetic knits and blends, permanent press) benefit from a cold rinse because of improved wrinkle resistance. -
Page 13: Before Transporting Washer To A New Location
NOTES: • Shut off hot and cold water outlets when washer is not in use. • Drain machine to prevent damage if washer will be subjected to freezing temperatures• Be sure the open end of the drain hose does not fall or drop down lower than the water level in the machine. -
Page 14: Washer Operation
Washer continues to fill or drain, cycle seems stuck Is the top of drain hose lower than the water level in washer? The top of the hose must be higher than the water level in the washer for proper operation. See the Installation Instructions. -
Page 15: Washer Results
Bid you sort properly? Sort lint givers (towels, chenille) from lint takers (corduroy, synthetics). Also sort by color. Did you overload the washer? The wash load must be balanced and not overloaded. Clothes should move freely. Lint can be trapped in the load if overloaded. Wash smaller loads. - Page 16 To purchasea protection agreementon a productservicedby Sears: 1-800-827-6655 Para pedir servicio de reparaciSn a domicilio, y para ordenar piezas: 1"888"SU'HOGAR _ (1-888-784-6427) 3948597B © Sears, Roebuck and Co. Your Home all major brand appliances, ® www.sears.com www.sears.ca Our Home Sears Parts &...