Index Safety first/1 Electrical requirements/2 Transportation instructions/2 Installation instructions/2 Suggested arrangement of food in the larder fridge/3 Temperature control and adjustment/4 Before operating/4 Getting to know your appliance/5 Defrosting/5 Replacing the interior light bulb/6 Cleaning and care/6-7 Repositioning the door/7 Do’s and don’ts/7-8 Trouble - shooting/8...
Instructions for use Congratulations on your choice of a Quality Appliance, designed to give you many years of service. Safety first! Do not connect your appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on, to allow compressor oil to settle, if transported horizontally.
Electrical requirements Before inserting the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. We recommend that this appliance be connected to the mains supply via a suitably switched and fused socket in a readily accessible position.
Keep food packed, wrapped or covered. Allow hot food and beverages to cool before refrigerating. Do not store explosive substances in the refrigerator. High proof alcohol must be stored upright in sealed containers. Leftover canned food should not be stored in the can.
Temperature control and adjustment Operating temperatures are controlled by the thermostat knob (Fig. 2) and may be set between 1 and 5, the coldest position. When the appliance is switched on for the first time, the thermostat should be adjusted so that, after 24 hours, the average fridge temperature is no higher than +5°C (+41°F ).
During defrosting, water droplets may form at the back of the larder refrigerator where a concealed evaporator is located. Some droplets may remain on the liner and refreeze when defrosting is completed.
Replacing the interior light bulb Should the light fail, switch off at the socket outlet and pull out the mains plug. Then ensure the bulb is screwed securely in the bulb holder. Replace the plug and switch on. If the light still fails, obtain a replacement E14 screw-cap type 15 Watt (Max) bulb from your local electrical store and then fit it (Fig.
Wrap cheese firstly in greaseproof paper and then in a polythene bag, excluding as much air as possible. For best results, take out of the refrigerator compartment an hour before eating. Wrap raw meat and poultry loosely in polythene or aluminium foil. This prevents drying.
Leave the door open for long periods Don't- as this will make the larder refrigerator more costly to run. Cover the shelves with any protective Don't- materials which may obstruct air circulation. Store poisonous or any dangerous Don't- substances in the larder refrigerator.