What To Do When Encountering Problems In The Basic Shooting Operations - Panasonic HEVC Advance AW-UE160WP Operating Instructions Manual
4k integrated camera
Hide thumbs
Also See for HEVC Advance AW-UE160WP:
- Operating instructions manual (64 pages) ,
- Operating instructions manual (64 pages)
Table of Contents
Advertisement
What to do when encountering problems in the basic shooting operations
If the trouble is not resolved by taking the action suggested below, refer
to "Troubleshooting" (→ page 197).
When performing operations from a wireless
remote control
The unit does not move.
• Press the CAMERA<1>, <2>, <3>, or <4> button to select the unit
which is to be operated.
If only one unit is being used, it is normally selected using the
CAMERA<1> button.
• If the unit's status display lamp is off or lights up orange, it means that
the unit's power is not on.
Refer to "Turning the power on" (→ page 37), and turn on the power.
• If the unit's status display lamp does not blink even when the wireless
remote control is operated near the unit's wireless remote control
signal light-sensing area, it means that the wireless remote control's
batteries have run down.
Replace the batteries.
Multiple color bands (color bars) are displayed.
Switch to the camera image by pressing the <MODE> button.
The menu screen is displayed.
Press the <MENU> button for 2 seconds to exit the camera menu.
The lens focus is not adjusted automatically.
Press the <FOCUS AUTO> button to switch to auto focusing.
The camera picture is too light or too dark.
• Press the <IRIS AUTO> button to switch the lens iris adjustment to
auto.
• Press the <AUTO> button of <GAIN> to switch the gain adjustment to
auto.
Something is wrong with the coloring of the camera
pictures.
Refer to "Auto tracking white adjustment (ATW)" (→ page 45), and
switch to [ATW].
The camera menus are not displayed.
Restart the camera and open any of the camera menus within about a
minute, the menus will be displayed in all the outputs.
When performing operations from a controller
The unit does not move.
• Select the unit to be operated by following the procedure below.
When using an AW‑RP150 or AW‑RP60
For details, refer to the operating instructions for the controller.
• If the unit's status display lamp is off or lights up orange, it means that
the unit's power is not on.
Refer to "Turning the power on" (→ page 37), and turn on the power.
• Check that the account settings for this unit have been set correctly.
(→ page 102)
• Network connection with AW-RP150 or AW-RP60 requires setup of an
initial account. (→ page 34)
When an initial account is not set up, AW-RP150 or AW-RP60 can
detect but cannot control this unit.
• When using a Panasonic controller (AW-RP150, AW-RP60), set
[Wait time mode] to [Mode2] when using digest authentication.
(→ page 167)
Smooth operation may be diminished when [Wait time mode] is set to
[Mode1].
Multiple color bands (color bars) are displayed.
Switch to the camera image by pressing the <BARS> button.
The lens focus is not adjusted automatically.
Press the <AUTO> button of <FOCUS> to switch to auto focusing.
The camera picture is too light or too dark.
• Press the <AUTO> button of <IRIS> to switch the lens iris adjustment
to auto.
• Press the <AUTO> button of <GAIN> to switch the gain adjustment to
auto.
Something is wrong with the coloring of the camera
pictures.
Refer to "Auto tracking white adjustment (ATW)" (→ page 45), and
switch to [ATW].
The camera menus are not displayed.
Restart the camera and open any of the camera menus within about a
minute, the menus will be displayed in all the outputs.
40
Advertisement
Table of Contents
