Advertisement
Available languages
Available languages
Quick Links
for Dishwasher Floor Mounting Kit
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or electrical shock.
NOTE: Floor mounting screws not supplied, must
purchase locally.
Instructions:
1. Remove two (2) screws from the access panel.
See Figure 1.
Access
panel
2. Carefully remove access panel and toe panel.
3. Position dishwasher in its finished installation position.
See dishwasher installation instructions for proper
installation position.
© Whirlpool Corporation 2000
(All Rights Reserved)
INSTRUCTION SHEET
Screws
Figure 1
wWARNING
Electrical Shock Hazard
Kit Contains:
2 Mounting Brackets
1 Instruction Sheet
4. Place floor mounting brackets on the inside of the
side braces as shown in Figure 2. The floor mounting
brackets must be at least 10" (254 mm) from the front
edge of the side brace.
Install brackets in these locations.
5. Mark location of hole on the floor for your lag screws.
6. Remove dishwasher and drill two (2) holes.
NOTE: Hole drill size will depend on size of lag screw
being used for installation. Lag screws not supplied.
Suggest
installation.
1
Place as far back as possible.
Figure 2
1
⁄
" lag screws, length determined at
4
(continued)
Instruction Sheet 8171478 6/00
Advertisement
Related Manuals for Whirlpool 8171477
Summary of Contents for Whirlpool 8171477
- Page 1 3. Position dishwasher in its finished installation position. being used for installation. Lag screws not supplied. See dishwasher installation instructions for proper Suggest ⁄ " lag screws, length determined at installation position. installation. (continued) © Whirlpool Corporation 2000 Instruction Sheet 8171478 6/00 (All Rights Reserved)
- Page 2 wWARNING Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. 7. Position dishwasher in its finished installation position. Secure mounting brackets to the floor. Recommend using lag screws purchased locally.
- Page 3 Les tire-fond ne d’installation du lave-vaisselle pour connaître la bonne sont pas fournis. Nous suggérons d’utiliser des tire-fond position d’installation. ⁄ de pouce; déterminer leur longueur au moment de l’nstallation. (suite) © Whirlpool Corporation, 2000 Feuille d’instructions 8171478 6/00 (Tous droits réservés)
- Page 4 wAVERTISSEMENT Risque de basculement Ne pas utiliser le lave-vaisselle jusqu’à ce qu’il soit complètement installé. Ne pas appuyer sur la porte ouverte. Le non-respect de ces instructions peut causer des blessures graves ou des coupures. 7. Positionner le lave-vaisselle dans sa position d’installation finale.