FAN SPEED MODE FAN,COOL,DEHUM. FAN SPEED :HIGH or LOW. SWING ENERGY SAVER Used to activate ENERGY SAVER option,reduce energy consumption and noise. POWER Front panel Air inlet (indoor side) Machine body Air outlet (indoor side) Air inlet (outdoor side) Display panel Power plug Air filter (inside)
FAN SPEED POWER MODE FAN,COOL,DEHUM. FAN SPEED TIMER button Used for TIMER start or stop . TEMP. or TIME set Used to set TIME or TEMP . setting . ENERGY SAVER SWING...
COOL 1.Start Press POWER button 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: Then select COOL operation. When the COOL display lights bright, the unit will be working under the cooling function. 3. Select temp. setting 4.
Page 6
4. Fan speed selection If you choose the FAN SPEED mode you can run the fan in one of the 2 speeds:HIGH OR LOW. Air conditioner is running under displayed fan speed. In DRY mode, when room temperature becomes lower than temp.setting+2 at LOW speed regardless of FAN setting.
FAN operation 1. Start Press POWER button. 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: Then select FAN operation. When the display lights bright ,the unit will be working under the fan operation. In some days you may want to run the FAN function.
ENERGY SAVER operation 1. Start Press POWER button. 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: Then select COOL operation. When the COOL display lights bright,the unit will be working under the COOL function. Saving energy function only can be used when A/C working on cooling condition.
Page 9
cool Press "On"of remote controller or "TIMER" of control panel, Press "Off "of remote controller or "TIMER"of control panel, TIMER ON mode restarted FAN SPEED FAN SPEED...
Power failure resume(please set and apply as necessary) If sudden power failure occurs, the unit will resume original operation when power is supplied again. Note: When sudden power failure happens during unit operation in power failure resume mode, if the air conditioner is not desired for use in a long period, please shut off the power supply in case that the unit automatically resume operation when power is re-supplied, or press POWER to turn off the unit when power resumes.
Page 11
pulling " CLOSE" the vent door opens to allow air, smoke position or odors to be expelled from the room; " OPEN"position, the vent door is closed and the air inside the room is circulated and conditioned. Pull CLOSE Pull OPEN...
Page 13
Disposal of the condensed water Generally there are two methods available on disposal of the condensed water: 1. Block the bottom plate hole of the conditioner with rubber lid, install outlet pipe fitting on the back hole and let the condensing water flow from the back hole of the conditioner. (See Fig.1 ) In this method, the accumulated condensed water in the bottom plate is hit by the fan onto the heat exchanger, and evaporated and blown out from the machine.
Page 15
Battery Name Manual (R-03 dry battery) Figure Quantity Outlet Sealed gasket Rubber lid pipe fitting Remote Screw controller...
Rated power input (W) 9000 980/1500 HW-09LN03 12000 1250/1600 HW-12LN03 Note: All capacities are gross. Haier THERMOCOOL reserves the right to change specifications as part of its policy of continuous improvement. WIRING DIAGRAM FAN MOTOR LOUVER MOTOR CN13 CN12 CN11 CN8 COMP.RELAY...
Page 18
With 3 years warranty on all air- conditioner compressors, you have peace of mind from the date of purchase NATIONWIDE SALES AND SERVICES MINNA,ILORIN,OSHOGBO,LOKOJA, sales office 2719790...