Table of Contents
Advertisement
[BTT370]
Thread the speaker cable through the base.
≥ Use cables with a white connector and red connector.
Leave about
110 mm
Preparing cables and making connection
1
Use of the speaker cable stickers is
convenient when making cable connections.
e.g. Front speaker (L)
A Speaker cable sticker (supplied)
B Connector
Speaker cable sticker
1 FRONT (L)
2 FRONT (R)
3 SURROUND (L)
4 SURROUND (R)
5 CENTRE
6 SUBWOOFER
≥ Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
≥ Don't use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable.
≥ To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.
≥ Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.
[BTT775] [BTT770] [BTT370]
∫ Preventing the speakers from falling
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of supporting over 10 kg.
e.g. [BTT775]
Tighten securely.
FRONT
Lch
Colour
WHITE
RED
BLUE
GREY
GREEN
PURPLE
Insert the wire fully.
r: White
s: Blue line
Press into the groove.
Back of the base
Pull the cable
straight along the
line and slide into
the groove.
Be sure to match the number on each sticker with the connector colour.
2
Connecting the speaker cables. Insert the
wire fully, taking care not to insert beyond
the wire insulation.
e.g. Surround speaker [BTT270]
A String (not supplied)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not supplied)
D Wall
E Approx.150 mm
Push!
r: White
s: Blue line
Push!
VQT3M06
13
Hide quick links:
Advertisement
Table of Contents
