2. Pull the front of the shelf support away
from the side wall.
3. Pull the rear end of the shelf support
away from the side wall and remove it.
1
4. Install the shelf supports in the opposite
sequence.
The retaining pins on the telescopic runners
must point to the front.
11.4 Pyrolytic Cleaning
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances installed in
the same cabinet, do not use them at the
same time as this function. It can cause
damage to the oven.
Do not start the function if you did not fully
close the oven door.
1. Make sure that the appliance is cold.
2. Remove all accessories.
3. Clean the oven interior and the inner door
glass with warm water, a soft cloth and a
mild detergent.
4. Turn the knob for the heating functions to
to enter Menu.
5. Turn the control knob to select
press
.
Cleaning programme
C1 - Light cleaning
C2 - Normal cleaning
C3 - Thorough cleaning
6. Turn the control knob to select the
cleaning programme and press
7. Press
to start cleaning.
20
ENGLISH
2
and
Duration
1 h
1 h 30 min
2 h 30 min
.
When the cleaning starts, the appliance door
is locked and the lamp is off. Until the door
unlocks the display shows
8. After cleaning, turn the knob for the
heating functions to the off position.
9. Wait until the appliance is cold and the
door unlocks. Clean the oven interior with
soft cloth and water.
11.5 Cleaning Reminder
When
flashes on the display after cooking
session, the appliance reminds you to clean it
with pyrolytic cleaning. You can turn off the
reminder in the submenu: Settings. Refer to
"Daily use" chapter, Changing: Settings.
11.6 Removing and installing door
The oven door has three glass panels. You
can remove the oven door and the internal
glass panels to clean them. Read the whole
"Removing and installing door" instruction
before you remove the glass panels.
CAUTION!
Do not use the appliance without the
glass panels.
1. Open the door fully and hold both hinges.
2. Lift and pull the latches until they click.
3. Close the oven door halfway to the first
opening position. Then lift and pull to
remove the door from its seat.
.