Table of Contents
Advertisement
WARNING
Electrical Shock or Personal Injury Hazard.
When the lower plate is removed for any reason, before reinstalling, be sure
that all electrical wires are routed in a manner that prevents them from coming into
contact with the lower plate, lower plate screws, or any moving parts. Be sure
the wires are not pinched in any way when the lower plate is reinstalled.
REMOVING/INSTALLING THE LOWER PLATE
Before replacing any parts, disconnect the vacuum -P- ..
—
cleaner from the electrical outlet
Lower
/
.—,
1
Plate
/
|
Pi
Replacing some of the parts in this section involves
r\-J!?~jn
J
I
the removal and installation of the lower plate
l *
YT| —
Lai[c".eJL
— p1]
Always place paper under nozzle anytime the lower
I
U
fl 7 \
R
|§j
plate ts removed to protect the floor surface
VI
/—\
M
To Remove Lower Plate
Start by placing the handle in the low position
(See
—A
the Handle Adjustments section ) Turn the vacuum
"Z
/i
— —y
cleaner over, exposing the underside Release the
lower plate by pressing the two (2) latches that secure
v^L,_
y
\__
the lower plate in the direction shown in the illustration
vy
/
y
j
Then remove the lower plate Brush or remove any
^
r
—%
residue that may exist in the belt area
/
To Reinstall Lower Plate
Hook the front end of lower plate into the slots on the front end of the nozzle housing Then
press the lower plate into place until a positive latching is felt
NOTE To insure maximum cleaning efficiency, the belt should be checked regularly to make
sure it is in good condition Check to see if the belt is stretched, cracked, or if
excessive slippage has occurred
Replace it if necessary
REPLACING THE HEADLIGHT BULB
1
Remove the lower plate using the procedure
in the Removing/lnstalling the Lower Plate
section
2 Grasp the bulb socket, wiggle the socket back
and forth while pulling it up out of the nozzle
housing To remove the old bulb, push it in
toward the bulb socket while turning
counterclockwise, then remove
3
Install the new bulb by pushing it in toward
the bulb socket and turning it clockwise
Use
any standard bayonet base appliance bulb
rated at 15 Watts
Caution
Do not use a bulb rated over
15 W During extended use, heat from the
bulb could overheat surrounding plastic parts
4 Reinsert the bulb socket into the nozzle housing by pushing it back down into the slot
Replace the lower plate as outlined in the Removing/Installing the Lower Plate section
-
13
-
Advertisement
Table of Contents
