Makita BS001G Instruction Manual page 8
Cordless belt sander
Hide thumbs
Also See for BS001G:
- Instruction manual (96 pages) ,
- Instruction manual (104 pages) ,
- Instruction manual (120 pages)
Advertisement
Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Switch action
WARNING:
For your safety, this tool is
equipped with the lock-off lever which prevents
the tool from unintended starting. NEVER use the
tool if it runs when you simply pull the switch trig-
ger without releasing the lock-off lever. Return the
tool to our authorized service center for proper
repairs BEFORE further usage.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released. Operating a tool
with a switch that does not actuate properly can lead
to loss of control and serious personal injury.
NOTICE:
Do not pull the switch trigger hard with-
out releasing the lock-off lever. This can cause
switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. The switch trigger is
locked when the lock-off lever is in the original position
and unlocked when the lock-off lever is pushed upward.
To start the tool, pull the switch trigger while pushing the
lock-off lever upward. Release the switch trigger to stop.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
2
Fig.3
► 1 . Switch trigger 2. Lock-off lever
For continuous operation, pull the switch trigger while
pushing the lock-off lever upward and then push in the
lock-on button. After that, release the switch trigger with
the lock-on button pushed in.
To stop the tool from the locked switch position, pull the
switch trigger fully, and then release it.
Fig.4
► 1 . Lock-on button
Front handle
The angle of the front handle can be adjusted in 4 steps
of 30°.
To adjust the angle of the front handle to a comfortable
working angle, loosen the clamping knob. Set the angle
of the front handle and tighten the clamping knob.
8 ENGLISH
1
1
Advertisement
